Advertisement
IMPORTANT
Systems include one Headset labeled "MAIN".
This MAIN headset must be
Turned "ON" to link the corresponding Remote headsets.
ON/OFF Power Button
1)
Click the power button on the MAIN headset.
Flashing green LED indicates power is ON.
2)
Press the power button on the REMOTE
headset(s).
3)
The LED on all headsets will flash & then turn
solid green indicating headsets have linked.
Note: to turn off, press and hold the power button
for 4-5 seconds. When LED blinks red, release.
Set Volume
EVADE feature five volume settings. Click UP or
DOWN buttons to adjust. Audible tone indicates low
or max volume.
Microphone Placement
Position the microphone one finger-width distance
from your mouth. Speak into the front of the
microphone, indicated by painted arrow and "Talk".
Each new EVADE series system arrives pre-programmed. Should you need to add to
your system please visit eartec.com/EVADE-programming.
Operation
ON / OFF Power
Volume UP / DOWN
Charging
1) Batteries are charged via the
multi-charger.
2) Insert the batteries making sure
the contacts are properly
aligned.
3) RED: Charging, GREEN: Fully
charged.
Installation
1) To eject battery from headset,
press the release button located
at the top of the compartment.
2) To insert battery into headset,
snap into place.
Low Indicator
1) A repetitive beep (20 sec.
intervals) indicates low power.
Battery should be charged or
replaced.
Battery Care
1) To preserve optimum charge level remove battery from
compartment when not in use.
AutoMute
Boom swivels over the top
270º Mic can be worn on
left or right.
Battery
Microphone mutes
automatically when boom
is set to "UP" position.
Advertisement
