Vixen Horns VXA7115L Installation Manual

BEFORE BEGINNING YOUR INSTALLATION

Read through the instruction guide before getting started with the installation. Professional installation is recommended for

this product.

 90-115 PSI Pressure Switch (1/4" NPT)

 Water-proof Cover with 10 gauge Wire Leads

The specific voltage requirement for this pressure switch is 12 or 24 volt DC, therefore installation must be done

to a DC power source of 12 or 24 volts.

 Make sure your battery ground is detached before getting your installation started.

 Employ equipment for eye protection during drilling operations.



Ensure that your air system has no pressure before starting the installation.



Pressure Switch has a rating of 90 PSI ON, 115 PSI OFF. When the air pressure in the air tank is below the

preset ON pressure (90 PSI), the compressor will automatically turn on and will start pumping air into the

tank. When the pressure reaches the cut OFF pressure (115 PSI), the compressor will be automatically shut

off.

PAGE 1 of 2

VXA7115L

INSTALLATION GUIDE

Table of Contents

Do you have a question about the VXA7115L and is the answer not in the manual?

Page 1 VXA7115L INSTALLATION GUIDE BEFORE BEGINNING YOUR INSTALLATION Read through the instruction guide before getting started with the installation. Professional installation is recommended for this product. CONTENTS  90-115 PSI Pressure Switch (1/4" NPT)  Water-proof Cover with 10 gauge Wire Leads The specific voltage requirement for this pressure switch is 12 or 24 volt DC, therefore installation must be done to a DC power source of 12 or 24 volts.
Page 2 VXA7115L INSTALLATION GUIDE MOUNTING  Apply thread sealant to pressure switch's threads and install it on one 1/4" NPT port available in the Air Tank. DO NOT OVER TIGHTEN.  Inspect the connection for leaks with a mixture of soap and water.