Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Belair SOLARLINK S1K2X
- Page 1 PLEASE READ THIS MANUAL BEFORE USE AND FOLLOW ITS GUIDANCE...
-
Page 2: Table Of Contents
INTRODUCTION SAFETY Earthing IN THE BOX INSTALLATION USING THE EQUIPMENT Suitable solar panels Connection sequence Disconnection sequence TECHNICAL SPECIFICATION TROUBLESHOOTING SUPPORT User Manual R1.0 2 / 12... -
Page 3: Introduction
INTRODUCTION The SOLARLINK module allows you to recharge or maintain charge on RESERVOIR or JUNCTION modules using standard solar panels. User Manual R1.0 3 / 12... -
Page 4: Safety
Replacement cables are available by contacting sales@belairtechnology.com Earthing The chassis of the SOLARLINK is electrically bonded to other chassis in a belair TOWER when the power cable is connected. It is permitted to connect any exposed metal of the User Manual R1.0... - Page 5 Neither the positive or negative pole of the solar panel should be connected to the chassis. It is recommended to follow local electrical regulations - please consult a local electrician if unsure.
-
Page 6: In The Box
IN THE BOX Belair SOLARLINK DC power cable Rack mounting screws User Manual QC certificate User Manual R1.0 6 / 12... -
Page 7: Installation
INSTALLATION It is recommended to install all belair equipment in suitable 19-inch enclosures. User Manual R1.0 7 / 12... -
Page 8: Using The Equipment
USING THE EQUIPMENT Suitable solar panels Standard solar panels are either nominally 12V or 24V. Since the belair system is nominally 48V, either 4 x 12V panels or 2 x 24V panels must be connected in series to generate sufficient voltage to charge the battery. -
Page 9: Connection Sequence
Turn on the JUNCTION or RESERVOIR Turn on the SOLARLINK Disconnection sequence Whilst the belair system and connectors are rated for connection under load, lifetime of the connectors will be dramatically increased by only manipulating the connections without load. The solar panel connectors are industry-standard MC4 type for convenience, however these... - Page 10 MODEL SOLARLINK S1K2X SYSTEM VOLTAGE MAXIMUM PV INPUT VOLTAGE 100V DC MAXIMUM CHARGE CURRENT RACK HEIGHT WEIGHT DIMENSIONS 89mm x 422mm x 203mm User Manual R1.0 10 / 12...
-
Page 11: Troubleshooting
TROUBLESHOOTING JUNCTION or RESERVOIR not charging Possible cause Solution Insufficient solar voltage Ensure all panels are exposed to sunlight Cabling error Check cables Solar LED not lit Possible cause Solution Solar panel voltage too low Not enough panels connected in series. Must be 4 x 12V or 2 x 24V Internal failure Contact support@belairtechnology.com... -
Page 12: Support
SUPPORT Contact support@belairtechnology.com User Manual R1.0 12 / 12...
Need help?
Do you have a question about the SOLARLINK S1K2X and is the answer not in the manual?
Questions and answers