Sony TRINITRON CPD-520GS Service Manual page 10

Customizing Your Monitor
Using the ZOOM On-screen
Display
The ZOOM settings allow you to enlarge or reduce the
picture.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the MENU button.
The MENU OSD appears.
MENU
2
Press the ¨./> and >?// buttons to select "
ZOOM," and press the MENU button again.
The ZOOM OSD appears.
3
Press the >?//buttons to adjust the picture zoom.
/ . . . to enlarge the picture
? . . . to reduce the picture
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
Note
The picture zoom adjustment will stop as soon as either the
horizontal or vertical size reaches its maximum or minimum value.
12
Get user manuals: See SafeManuals.com
Using the COLOR On-screen Display
You can change the monitor's color temperature. For
example, you can adjust or change the colors of a picture on
the screen to match the actual colors of the printed picture.
Once the setting is adjusted, it will be stored in memory for
all input signals received.
1
Press the MENU button.
The MENU OSD appears.
MENU
2
Press the ¨./> and >?// buttons to select "
COLOR," and press the MENU button again.
The COLOR OSD appears.
COLOR
ZOOM
5000K
H 26
V 73
3
Press the >?// buttons to select the color
temperature.
There are three color temperature modes in the OSD.
The preset adjustments are:
5000K, 6500K, 9300K
4
Fine tuning the color temperature
Press the ¨./> buttons to select R (red), G (green), or B
(blue) and adjust by pressing the >?// buttons.
The "5000K," "6500K" or "9300K" disappears and the
new color settings are memorized for each of the three
color modes.
The color temperature modes change as follows:
5000Kn 1, 6500Kn 2, 9300Kn 3
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on. The
6500K 9300K
R 50
G 50
B 50
Getting Started
Customizing Your Monitor
Using the SCREEN On-screen
Display
COLOR
You can adjust convergence settings to eliminate red or blue
1 6500K 9300K
shadows that may appear around objects on the screen.
R 76
G 50
Adjust the CANCEL MOIRE function to eliminate wavy or
B 50
elliptical patterns that may appear on the screen.
Adjust the LANDING function to correct color imbalances
at the four corners of the screen due to influence from the
earth's magnetism.
Once CANCEL MOIRE is adjusted, it will be stored in
memory for the current input signal. All other adjustments
will be stored in memory for all input signals received.
1
Press the MENU button.
The MENU OSD appears.
MENU
2
Press the ¨./> and >?// buttons to select "
SCREEN," and press the MENU button again.
The SCREEN OSD appears.
SCREEN
selected item is reset to the factory settings.
TOP
BOT
ADJ
3
Press the ¨./> buttons to select the item you want
to adjust.
Select To
adjust the horizontal convergence
H CONVERGENCE
adjust the vertical convergence
V CONVERGENCE
TOP adjust the screen's upper vertical
convergence
V CONVER TOP
BOT
adjust the screen's lower vertical
V CONVER BOTTOM convergence
(continued)
EN
F
ES
C
26
H CONVERGENCE
13