Download
Share
Print this page
  1. Manuals
  2. Brands
  3. RAK Manuals
  4. GPS
  5. WisBlock Kit 3
  6. Installation manual

RAK WisBlock Kit 3 Installation Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Documentation Center
Installation Guide
Assembly List
Figure 1: Assembly list
Assembly
Step 1: Fix the WisIO module with three M1.2*3 screws. For assembly method and precautions, refer to
RAK5005-O Baseboard Installation
Guide.
Figure 2: Attaching WisIO Module
Step 2: Fix the WisBlock module on the plate with M2.5*4 screws.
NOTE
The number of screws is related to the specific module, confirm according to the actual module.
Figure 3: Attaching WisBlock Module to the Enclosure

Advertisement

loading

Related Manuals for RAK WisBlock Kit 3

Summary of Contents for RAK WisBlock Kit 3

  • Page 1 Documentation Center Installation Guide Assembly List Figure 1: Assembly list Assembly Step 1: Fix the WisIO module with three M1.2*3 screws. For assembly method and precautions, refer to RAK5005-O Baseboard Installation Guide. Figure 2: Attaching WisIO Module Step 2: Fix the WisBlock module on the plate with M2.5*4 screws. NOTE The number of screws is related to the specific module, confirm according to the actual module.
  • Page 2 Documentation Center Step 3: If N-type antenna are required, remove the plugs and replace it with the N-type antenna connector and fix it in place. The other end of the cable is plugged to the IPEX connector of the WisBlock. Figure 4: Attaching Antenna Step 4: If the built-in antenna is used, please stick the built-in antenna on the inner wall of the enclosure, as shown in the figure below.

  • Page 3: Installation Wall Mounting

    Documentation Center Figure 7: Cover Installation Wall Mounting Step 1: Use Ø6mm drill head, drill 4 holes on the wall according to the dimension of the following picture and then plug the screw anchors in the wall; Figure 8: 4 Drill Holes Step 2: Use the tapping screws, attach the device to the wall.

  • Page 4: Pole Mounting

    Documentation Center Figure 9: Wall mounting Pole Mounting Step 1: Fix the installation kit on the bottom of the enclosure with four M4*8 screws; Figure 10: Pole mounting - Installation Kit Step 2: Slide the Steel band clamps through the rectangular hole of the mount kit, wrap the band clamps around the pole, lock them and then tighten the clamps using a screwdriver.
  • Page 5 Documentation Center Figure 11: Pole mounting - Attaching Band Clamps Protection treatment Seal the N-type antenna: Step 1: Connect the N-type antenna to the connector on the enclosure and fix it tight. Clean the surface of the area to be wrapped, wrap a layer of PVC tape with 50% overlap around the connector and the about 10mm of the foot of the antenna.
  • Page 6 Documentation Center Figure 14: Protection treatment - Step 3 Last Updated: 7/29/2022, 10:17:19 PM...