inventum VMC-47VJ54 Installation And Operation Instruction

Installation and operation
Instructions
VMC-47VJ54 (RF-receiver)
1. How to use this manual
This manual is intended as a reference book by which
qualified installers can install the VMC-47VJ54 (henceforth
called "device") and users can use the device for its intended
purpose. Make sure you have read and understood the
manual before you install and/or use the device.
1.1 Admonitions
'Warning' identifies a hazard that could lead to
personal injury, including death.
'Note' is used to highlight additional information.
1.2 Intended use
The device is designed for following purposes:
To set the speed level of ventilation through the fan speed,
based on user input, measured humidity level, or measured
CO level.
2
Every other or further use is not in conformance with the
intended use.
1.3 Working principle
The device outputs a 0-10V DC signal to control a ventilation
system. To define how the ventilation system must be
controlled, the device receives input from one or more control
device(s) via wireless communications. Various control
devices are available: push button controls, humidity sensors
and CO sensors. The device sends status information back
2
to all connected control devices.
1.3.1 Ventilation speeds and modes
The ventilation system runs in one of the following modes.
Mode Fan speed
Away Low
Home Medium
Timer High for restricted
period
Auto Low-High based on
measured values
Party High
The device drives the fan based on the highest of values sent
by the bound wireless sensor(s). You can use the bound
wireless sensor(s) to modify the configured fan speeds.
A: Status-led
Default
20%
50%
80%
100%
2. Content delivery
•
RF-receiver (VMC-47VJ54)
•
Mounting screws
•
Mounting plugs
•
Manual
3. Visual signals
Start up Orange
Status
OK Green
Communication RED
error
Fan error
Configuration
Binding Red / green
4. Safety
The device meets the following EC directives:
•
EMC directive:
•
Low voltage directive: 2014/35/EU
•
RTTE directive:
•
RoHS directive:
•
WEEE directive:
4.1 Signs on the device
Check the instructions for use for important
cautionary.
Risk of electric shock.
IEC 61140 protection Class II (double insulated).
CE marking of conformity.
Dispose according to European Community
Directive 2012/19/EU (WEEE).
General safety instructions
This product was designed and manufactured to ensure
maximum safety during installation, operation, and
service. Always read these safety instructions before
installing, maintaining, or servicing the product, and
strictly comply with these instructions. Parts of the
device carry mains power, which is a potential lethal
voltage. Disconnect power at supply line, circuit breaker
or fuse before installing, servicing, or removing the
device.
The device is designed for indoor use only. Do not
expose the device to rain or moisture, to avoid short
circuit. Short circuit may cause fire or electric shock
hazard. Operate the device between 0°C and 40°C. For
cleaning of the device use a soft damp cloth only. Never
use any abrasive or chemical cleaner.
1
2
2
1
Status led
Continuous
Continuous
1 flash
3 flashes
1 flash
2014/30/EC
2014/53/EU
2011/65/EU
2012/19/EU