Download Print this page

Boss BARRE PRO Assembly Instructions

Advertisement

Quick Links

EXTENDED BOSS BARRE PRO ASSEMBLY INSTRUCTIONS
On a clean surface that will not scratch the finish of the
bars, place two of the horizontal sections of one side of the
barre parallel to each other. Take the two specially made
Reinforcement pieces and place one each in-line of the
horizontal bars:
Line up the pre-assembled Center Support section
perpendicular to the horizontal pieces that now have the
Reinforcement pieces inside, with set screws facing up:
Slide the pre-assembled Center Support until the yellow
lines just disappear, and TIGHTEN LIGHTLY. Do NOT fully
tighten the set screws at this point:
PAGE 1
1.
3.
5.
Slide the Reinforcement pieces into the horizontal sections
until the ring-stoppers come into contact, as shown below:
Slide the pre-assembled Center Support over the horizontal
pieces until it lines up with the yellow markings:
Slide other horizontal bars onto the Reinforcement pieces
and into the pre-assembled center support, until they come
to a stop against the ring-stoppers. Please note that the fit
is intentionally very tight. You may have to slightly "wiggle"
the horizontals to get them in place. LIGHTLY TIGHTEN set
screws. Do NOT fully tighten the set screws at this point:
CONTINUED ON PAGE 2
2.
4.
6.

Advertisement

loading
Need help?

Need help?

Do you have a question about the BARRE PRO and is the answer not in the manual?

Questions and answers

Summary of Contents for Boss BARRE PRO

  • Page 1 EXTENDED BOSS BARRE PRO ASSEMBLY INSTRUCTIONS On a clean surface that will not scratch the finish of the Slide the Reinforcement pieces into the horizontal sections bars, place two of the horizontal sections of one side of the until the ring-stoppers come into contact, as shown below: barre parallel to each other.
  • Page 2 FULLY tighten all set connectors on the base stabilizers: screws on the entire barre, once you have ensured that all pieces are square: ENJOY YOUR EXTENDED BOSS BARRE PRO!