Advertisement
Table of Contents
Probe Stand Quick Start Guide
Stand Parts
The Probe stand consist of the following
parts:
•
1 x Stand foot
•
1 x Probe holder
•
3 x Tube connector pieces
•
1 x Top tube lid
•
1 x 80cm tube
•
3 x 50cm tube
Assembly
1.
First place/slide the longest 80 cm into the foot of the stand.
2. Then use the connector pieces to connect the remaining three tubes of 50
cm and end with the lid.
3. Place the probe holder over the tubes and tighten it with the screw at the
back.
1
1
2
2
3
3
4
5
4
6
6
5
Advertisement
Table of Contents
Related Manuals for raditeq Probe Stand
Summary of Contents for raditeq Probe Stand
- Page 1 Probe Stand Quick Start Guide Stand Parts The Probe stand consist of the following parts: • 1 x Stand foot • 1 x Probe holder • 3 x Tube connector pieces • 1 x Top tube lid • 1 x 80cm tube •...
- Page 2 Probe Stand Quick Start Guide 230CM 50CM The probe holder can be either, moved over the 180CM completed tube to match te desired height. Or can be attached at the last top tube and when height adjustment is need the seperate tubes are added.
Need help?
Do you have a question about the Probe Stand and is the answer not in the manual?
Questions and answers