Advertisement
These are just examples – GSMOutdoorAlert2 can be fully configured using the same format shown in the
examples above with the details as per the commands in the table below:
Full SMS Command Table
Description
Change Password
Add Admin (Up to 3 can be added)
Delete Admin
Alert Calls Activate
(Unit will RING as well as send the SMS)
Alert Calls Deactivate
Change SMS Text Messages
(Customise the SMS message that will be
sent when Inputs are closed/opened)
Note change x to 1 -4 or 9-12 end with #
Periodic Keep Alive (Heartbeat) SMS
Message
(set the interval time in hours)
Keep Alive Message Text
Get Device Status Info (Reply will show
CALL/KeepAlive & Signal between 0 and 31)
Restore Factory Settings
Note: To preserve its batteries (up to 1 year with normal use) the GSMOutdoorAlert3 will go into sleep mode
after 2 minutes following configuration. It will only wake and communicate when:
•
An input has activated.
•
A keep alive heartbeat SMS is being sent.
•
The config button has been pressed.
Refit the cover back on the device after you've got a confirmation SMS that the commands have been saved and
you're good to go! SeNd Technology have 20 years' experience so if you have any questions of need any help
just get in touch.
www.sendtech.co.uk
Technical Specifications
Power: 2x CR123A lithium batteries
Battery Life: More than 1 year under normal use
Inputs: 4 x volt-free
GSM: 2G Quad band 850/900/1800/1900 MHz
Antenna: SMA
Operating Temperature: -10 to +50degC
Dimensions: 115 x 90 x 55 mm IP67 Water & dust protection
Package includes: GSMOutdoorAlert device, IP seal, fixing screws.
or call 01488 762 763
:
COMMAND
Default
PASS:xxxx
1111
ADDA:xxxxxxxxxx
DELA:xxxxxxxxxx
CALL:ON
OFF
CALL:OFF
OFF
PATx:YourText#
KA:x
0 (off)
PAT0:YourText#
STATUS
RESET
Range
Who can alter
0000..9999
ADMIN
ADMIN
ADMIN
ADMIN
ADMIN
1..32 chars
ADMIN
0...999 hrs
ADMIN
1..32 chars
ADMIN
ADMIN
ADMIN
©SeNd Technology 2022 V1
Advertisement
