Woodhaven 2720 HD Manual

Identify and verify that you have all the parts listed.
You'll need a #3 Phillips screwdriver for assembly. Read
thru the instructions at least once before any assembly.
The Work Fence (2715A) can
A
be mounted at the front (shown)
or back (shown on back
page) of the Guide Base (2720B)
depending on your preferance.
Where you mount it also
depends on whether your saw
is a right or left hand model
(right hand shown). Install
the Work Fence, with
its grip tape facing the
Guide Base and even
with the front or back edge
of the Guide Base, using two 3/4"
flat head screws (MF010) and two oval
nuts (5760B - flat side first). Position its
end at least 1" away from the Guide Base
edge to clear the eventual blade path.
Determine position
B
of Saw Fence (2720T)
from the edge of the
Guide Base by measuring
the wide part of your saws
base edge-to-blade distance.
Based on this measurement,
C
select the mounting holes for the
Saw Fence to the Guide Base that
will allow a clean cut along the entire
edge of the Guide Base while removing the
least amount (1/2" or less) of material.
Install and square the Saw Fence
D
in selected position on Base using
four 1/2" flat head screws (MF005)
and four oval nuts (5760B - flat side
first). Position one end of the Saw Fence
even with the outfeed edge of the Base
and the opposite end overhanging the
infeed edge of the Base about 2-3/4".
The overhanging Saw Fence is the
end you start feeding the saw from.
t - H
g h
a r
R i
u l
r c
C i
B
MF010 x2
C
A
E
p
a m
C l
Set the cut depth of your saw so the underside of the saw
E
motor clears the top of the 3/8" tall Saw Fence. Approximate
max depth of cut with a 7-1/4" saw is 2-3/16".
Clamp or hold the HD Saw Guide/Work Fence against a scrap piece of
2x material, power on your saw and run it along the Saw Fence to trim the
Guide Base. It is now zeroed out with a clean edge and ready for use.
F
Use the zero clearance edge to position the HD (Heavy Duty) Saw
Guide where required on the work, clamp or hold it in position and
make the cut. Can be used outside without damage from rain, etc.
2720 HD
Saw Guide
Please Read Carefully!

Parts List:

Part Description
2720B X-Large Saw Guide Base - 26" capacity . . . .1
2720T 29-1/2" One Track - Saw Fence . . . . . . . . . . .1
2715A 16" Work Fence w/Grip Tape . . . . . . . . . . . . .1
MF005 1/2" Flat Head Screw . . . . . . . . . . . . . . . . . . . .4
MF010 3/4" Flat Head Screw . . . . . . . . . . . . . . . . . . . .2
5760B Oval Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
d
a n
w
S a
2720B
5760B x2
2 7
1 5
A
Quantity
S q
u a
r e
T
2 0
2 7
MF005 x4
D
5760B x4