HeiSolar FF Series User Manual

How to check if your solar billboard /floodlight
is working properly?
After installation completed, the lamp will be lighting automatically, and turn off
1
automatically after one minute, prove that the lamp body is working properly.
The day, you can see the green indicator light on the microwave probe flashes,
2
indicating that the solar panel is charging the lamp, and the lamp will automatically
light up at night.
See the red indicator light on the microwave probe flashing, indicating that the
3
battery is losing power. Please let the solar panel charge the lamp body in the
sunlight for 5-6 hours until the indicator light on the microwave probe flashes green,
the battery has electricity, and the night light The body will automatically light up.
Working mode & ON OFF time
The light turn on at dusk with a pre-programmed setting function and work continues
till dawn, The ON and OFF functions are controlled automatically by the built-in
charge controller with light-sensitive timings. At sunset NTTV (Night Time Threshold
Voltage) goes less than 5 volts from the solar panel, the lights will turn ON. In the
morning the DTTV (Day Time Threshold Voltage) from the panel reaches 5 volts the
lights will turn OFF.
Automatically ON
Once dark
50%
100%
3hrs
4hrs
( Customized working mode as respect to customer's different requirement )
You can also use the remote control to change the different lighting modes required.
2 3
1
OFF MODE DEMO MODE
4 workig modes on remoter
Test button ( light "on" for 1 mintue).
On/Off button ( press the button turn on the light, press again turn off the light,
no matter day or night ).
1
100% 6hrs+50% 6hrs
2 100% 3hrs +50% 4hrs +30% 5hrs (deafult lighting mode)
3 100%-2hrs+70%-2hrs+50% 2hrs；50% when people come , 20% far away-6hrs
4 100%-3hrs+when people come 80%, far away 40%-4hrs+when people come 50%,
far away 20%-4hrs
Attention to operation
1 Do not remove or dismantle the MC4 connectors or try to plug in the light as the
polarity can go wrong IN CASE OF DAMAGE OF LIGHT.
2
Do not open the light fixture by unauthorized persons, can affect the IP rating of
the fixture and void the warranty.
3 There has one minute delay for the ON/ OFF function. There has one minute
delay for working mode changes. The light will turn off after one minute once
the panel is disconnected or at sunset.
Clean surface of solar panel regular such as dirty leaves, oil. ect, ensure high
4
photoeletric conversion efficiency.
Set suitable angle towards sun, (≈local latitude).
5
Please avoid solar panel being shielded by buildings, trees, antenna mast or
6
othe obstructions, otherwise it will reduce working efficiency of solar panel.
7 Recharge battery every 3 month at least if it is idled.
Automatically OFF
Till the morning
8 Charge temperature of Lithium battery is from 0℃ to 55℃, the discharging
30%
temperature is from -20℃ to 60℃, make sure that ambient temperature is in
5hrs
this range when used, avoid damage to lithium battery.
Clean snow on solar panel surface timely in winter.
9
4
2
1 3
4
Address: F4, 6th Building, Hengguangyao Industrial Park, Yonghe Road, Heping Village, Fuyong Street, Bao'an
District, Shenzhen City, Guangdong Province, China.
E-mail: info@heisolar.com Website: www.heisolar.com
User Manual-FF Series
Solar LED Flood Light