Related Manuals for SMA TEMPSENSOR-AMBIENT
Summary of Contents for SMA TEMPSENSOR-AMBIENT
- Page 1 Ambient Temperature Sensor TEMPSENSOR-AMBIENT Installation Guide TempsensorAmb-IEN110610 | 98-0042210 | Version 1.0...
-
Page 3: Table Of Contents
SMA Solar Technology AG Table of Contents Table of Contents Notes on this Guide ....... 4 Area of Validity. -
Page 4: Notes On This Guide
This guide describes the installation and commissioning of the Ambient Temperature Sensor. Store this guide where it will be accessible at all times. 1.1 Area of Validity This guide applies to the TEMPSENSOR-AMBIENT upgrade kit. 1.2 Target Group This guide is for electrically skilled persons. -
Page 5: Safety
Ambient Temperature Sensor is between –30 °C and +80 °C. Connect the sensor to Sunny SensorBox for further processing of the ambient data. The Ambient Temperature Sensor is suitable for use only with original SMA accessories or with accessories recommended by SMA Solar Technology AG. -
Page 6: Scope Of Supply
Scope of Supply SMA Solar Technology AG 3 Scope of Supply Position Quantity Description TEMPSENSOR-AMBIENT (Ambient Temperature Sensor) Screw Screw anchor TempsensorAmb-IEN110610 Installation Guide... -
Page 7: Assembly
SMA Solar Technology AG Assembly 4 Assembly 4.1 Selecting the Mounting Location • The Ambient Temperature Sensor must be assembled with the cable gland pointing downwards in order to prevent water from accumulating on the cable gland. • Protect the Ambient Temperature Sensor from severe contamination and spray. -
Page 8: Electrical Connection
• Outer cable diameter: at minimum 4.5 mm, at maximum 7 mm • UV-resistant SMA Solar Technology AG recommends the following cable types: • Lappkabel: UNITRONIC S-LifY11Y 4 x 0.34 mm • Lappkabel UL-listed: UNITRONIC S-LifY11Y 4 x 0.34 mm... -
Page 9: Connecting Cables To The Ambient Temperature Sensor
SMA Solar Technology AG Electrical Connection 5.1 Connecting Cables to the Ambient Temperature Sensor 1. Undo the screws on the Ambient Temperature Sensor enclosure and remove the lid. 2. Remove the cable glands on the Ambient Temperature Sensor. 3. Remove the small interior protection plates. Make sure that the interior seal does not fall out. -
Page 10: Connecting The Ambient Temperature Sensor To The Sunny Sensorbox
Electrical Connection SMA Solar Technology AG 5.2 Connecting the Ambient Temperature Sensor to the Sunny SensorBox The Ambient Temperature Sensor is connected to the "F6: TmpAmp" terminal of the Sunny SensorBox. Proceed as follows: NOTICE! Damage to the Sunny SensorBox due to ingress of fluids •... - Page 11 SMA Solar Technology AG Electrical Connection 5. Remove resistance and bridge at the "F6: TmpAmb" terminal in the Sunny SensorBox. 6. Connect the Ambient Temperature Sensor to the "F6: TmpAmb" terminal of the Sunny SensorBox. Please note the indicated wire colors (see page 9).
-
Page 12: Decommissioning
At the end of its life cycle, dispose of the Ambient Temperature Sensor in accordance with the applicable disposal regulations for electronic waste at the installation location at the time. Alternatively, return it labeled as "ZUR ENTSORGUNG" ("for disposal") to SMA Solar Technology AG, at your own expense. -
Page 13: Technical Data
Protection rating IP65 Connection cable Maximum cable length 30 m Measurement Range and Tolerances Tolerance at maximum ± 0.7 °C (class B) Measurement range − 30 °C … +80 °C not included in SMA scope of supply. Installation Guide TempsensorAmb-IEN110610... -
Page 14: Contact
Contact SMA Solar Technology AG 8 Contact If you have technical problems concerning our products, contact the SMA Serviceline. We need the following information in order to provide you with the necessary assistance: • Ambient temperature sensor model • Sunny SensorBox firmware version •... - Page 15 The use of supplied software produced by SMA Solar Technology AG is subject to the following conditions: • SMA Solar Technology AG rejects any liability for direct or indirect damages arising from the use of software developed by SMA Solar Technology AG. This also applies to the provision or non-provision of support activities.