Advertisement

Quick Links

Combustible Gas
Detector

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Combustible Gas Detector and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for heimgard Combustible Gas Detector

  • Page 1 Combustible Gas Detector...
  • Page 2: What Is In The Box

    What is in the box Metal Gas Detector...
  • Page 3: Device Overview

    Device overview Join/Reset Button Testing button Indicator Gas convection holes...
  • Page 4 Connect the device (A) to a wall socket Open the Heimgard app and follow the steps listed here to connect to your device:...
  • Page 5 Insert the metal pin (B) and press join button (C) 3 seconds while your app is scanning for the device Your device will appear in the Found Devices list. Click configure to add the device to a specific room. The device is preconfigured as part of your alarm system and will sound when alarm is triggered.
  • Page 6 Mounting Before use, confirm whether the gas that is to be detected is heavier or lighter than air. If the gas has heavier density than air, install the device 30-100 cm above the floor with less than 150 cm from the gas source. LPG for example. If the gas has lighter density than air, install the sensor install the device 30-100 cm below the ceiling and less than 150 cm from the source.
  • Page 7: Led Description

    LED Description Standby Solid Green Warm up Alternate flashing green/red/yellow Test Alternate flashing green/red/yellow Sound «Di-di» Alarm Red Flashing Sound «Di-di» Fault Yellow solid Sound: Long «diiii» Troubleshooting Insert the metal pin (B) and press the reset button (C) for 5 seconds to disconnect the device from the network.
  • Page 8 Need help? Website: heimgard.com/support Email: support@heimgard.com Facebook: facebook.com/heimgardnorge/ Telephone: +47 649 44 422 Visit heimgard.com for more information and tips on how to use.
  • Page 9: Important Safety Information

    Important safety information Read through these instructions and follow accordingly. Clean only with dry soft cloth. Household cleaners and solvents can damage the finish on your device. Do not install near any heat sources such as radiators, heat registers, stoves or other device that produce heat. Do not use this device near water.
  • Page 10 heimgard.com...

Table of Contents