Ortus Repeater-R Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Attention! Reliability and life of the product are provided not only by the quality of product itself,

but also by the compliance with operating modes and conditions, therefore, this document require-

ments is mandatory

ORTUS Group

Relay-R

Wireless Repeater

Repeater-R

Operation manual

Product Compatibility Table

Compatible radio receiver

Configuration Software

Central Monitoring Station

Version en_2

Version

Lun-R

Version

Configurator 11

Version

Orlan

Table of Contents

Need help?

Do you have a question about the Repeater-R and is the answer not in the manual?

Questions and answers

Summary of Contents for Ortus Repeater-R

Page 1 Attention! Reliability and life of the product are provided not only by the quality of product itself, but also by the compliance with operating modes and conditions, therefore, this document require- ments is mandatory Wireless Repeater Repeater-R Operation manual Product Compatibility Table Version...
Page 2 Contents 1. Purpose..................................... 3 2. Safety Precautions................................. 3 3. Technical specifications...............................3 4. How to use..................................4 4.1. Modes Indication..............................4 4.2. Binding..................................5 4.3. Wireless signal strength............................. 5 4.4. Installing................................. 6 5. Maintenance..................................6 6. Operating conditions..............................6 7. Storage....................................6 8.
Page 3 1. Purpose The wireless Repeater-R (hereinafter referred to as the “repeater”) is designed to increase the range of wireless detectors to the Lun-R receiver that is connected to the Lun control panel (more about for compatibility, see the documentation of the relevant control panel).
Page 4 4. How to use The repeater’s PCB is placed in a plastic enclosure with a removable cover (Figure 1). A tamper switch, a power terminal block, a battery holder, a multi-color LED indicator, an an- tenna terminal block and START contacts to initiate the process of binding with the Lun-R receiver are placed on the repeater’s PCB.
Page 5 4.2. Binding A new repeater must be bound to the control panel in order to successfully transmit com- mands from receiver. The repeater can be bound when it is powered only from a pre-charged battery. The mains power must be disconnected! To register a repeater, do the following: 1.
Page 6 4.4. Installing To install the repeater: 1. Choose a place for installation, taking into account the signal strength in this place (see section 4.3). It is recommended to orient the repeater during installation so that its an- tenna is located vertically. Do not place repeater on or near metal surfaces (closer than 1m), or inside metal structures;...
Page 7 Manufacturer: ORTUS Group 1 East Liberty, 6th Floor Reno, NV 89501, USA Tel.:+1 650 240 27 62 mail: info@ortus.io http://www.ortus.io Relay-R Version en_2...