Power Probe The Hook Operation Manual page 2

The Power Probe Hook Operations Manual
Thank you for purchasing Power Probe's Hook electronic circuit tester. Ergonomically designed so it can be
"Hooked" to the vehicle thus eliminating the need to balance it on a fender or worse, lay on the floor where
it could be crushed or stepped on! The Hook is designed to give you years of trouble free diagnostic power,
If you have any questions please go to our website www.powerprobe.com or give us a call: 800-655-3585.
• Power Probe recommends reading this manual before using the Hook.
• This product is designed to be powered from DC power sources such as found in Automotive,
Small Craft Marine and Small Craft Aviation electrical systems and will be damaged if
connected to line voltage such as 115V AC power sources or 24V AC Control circuits.
• Do not connect to electrical systems with higher than the rated voltage as specified in
this manual.
• Before using, inspect the case, probe tip, cable and accessories for damage. When in doubt,
have the Hook serviced by Power Probe's repair department.
• Do not use Hook if it operates abnormally, the safety features may be disabled. When in doubt,
have the Hook serviced by Power Probe's repair department.
• Only operate in well ventilated areas, do not operate around flammable materials, vapor or dust.
• Only use shrouded leads and accessories authorized by Power Probe to minimize
exposed conductive electrical connections to eliminate shock hazard.
• Due to the high output currents the Hook produces, be careful when energizing components
that have moving parts, assemblies containing motors or high powered solenoids.
• Do not open the Hook, no serviceable parts are inside. Opening the Hook voids the warranty.
• Power Probe, Inc. shall not be liable for damage to vehicles or components caused by misuse.
• The Hook should not be left unattended while connected to a circuit or used by untrained
technicians.
• Power Probe, Inc. shall not be held liable for any harm caused by unintentional or
intentional misuse of our products or tools.
even in the most demanding work environments.
CAUTION - PLEASE READ
The Serial Number can also be found on the back of the unit or box.