Table of Contents
Advertisement
The mains plug must be freely
■
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
From ~ Page 29
Never use a damaged machine.
■
Inform your after-sales service.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the water tap.
4.
Close the washing machine door (do
5.
not load any laundry).
Select thei Cottons programme
6.
and set the temperature to 90 °C.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
Close the detergent drawer.
10.
Press Start.
11.
Positioning and connecting
Switch off the appliance at the end of
12.
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 23
Drain the remaining detergent
3.
solution.
Maintenance – detergent solution
pump blocked ~ Page 22
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
en
35
Advertisement
Table of Contents
