Page 1 CONTENT I. USER MANUAL 1. Technical information 1.1 Package content 1.2 Technical specifications 1.3 Main components of the machine 1.4 Installation 1.5 Operation cautions, warnings and instructions 1.6 Sterilization/Disinfection 1.7 Regular maintenance 1.8 Troubleshooting II. WARRANTY 2. Warranty policy 2.1 Warranty scope 2.2 Manufacturer’s warranty 2.3 Terms of delivery 2.4 Disposal information...
Page 2 1. Technical information Package content Main machine T-12 1 pc. Handpiece support 1 pc. Power cord 1 pc. Crossover cable for T-units 1 pc. Working handpiece with a wire and active electrode 1 pc. Contact handpiece with a wire and passive electrode 1 pc.
Page 3 The main machine Т-12; Treatment handpieces; Crossover cable for T-model units; Power cable; User manual; Control panel of the T-12 machine is shown below: 1. POWER button 2. Time indicator - TIMER 3. INTENSITY indicator 4. START/STOP button 5. Time set buttons...
Page 4 1.4 Installation To install the T-12 machine, proceed as follows: 1. Place the unit on a flat surface. 2. Connect the machine to the mains using the power cord. 3. Connect the working handpieces (active and passive) into the handpiece connectors on the back panel of the device.
Page 5 11. After transportation at a low temperature, before starting operation, the device must be kept for at least 3 hours at a temperature of from +10 to +35 ° C. 12. During operation, the patient and service personnel are prohibited to touch the metal parts of other equipment that is powered by the building's power supply network, as well as metal parts that are grounded or have a large capacity relative to the ground.
Page 6 power outlet and the main voltage is present in the socket. If necessary, change the power cable. Make sure that the POWER button is on. Check the Fuse and if necessary, change it. Check if the handpieces are connected to the machine. No current Check if the patient holds tightly in the hand the contact on the treatment tip...
Page 7 consumer, and, if necessary, conduct a quality check of the goods. The consumer has the right to participate in quality control goods In the event of a dispute about the causes of deficiencies of the goods, the manufacturer or organization that performs the functions of the manufacturer must examine the goods at its own expense.
Page 8 Disposal information This equipment doesn't contain components that can adversely affect human health and pollute the environment. After the end of their service life (5 years), they can be recycled without special disposal methods. Component parts (chips, resistors, capacitors, etc.) that are operable after the end of their service life may be used as spare parts for repairs of such and similar devices.