Subscribe to Our Youtube Channel
Summary of Contents for Lainly CS1
- Page 2 Thank you for purchasing your new Lainly Portable Partition Wall. Please use these assembly instructions to get everything set up. Before you begin building, confirm you’ve got everything you need to continue – and make sure there’s a Phillips or flathead screwdriver handy.
- Page 3 STEP TWO • To correctly position the base feet just make sure that the screw holes for the wheels are facing down (toward the floor). • The screw holes for the bottom pole connections should be facing each other when laid out on the floor. •...
- Page 4 STEP TWO (CONTINUED) • Grab your screwdriver and attach each bottom pole to its respective base foot using two screws and washers for each side. STEP THREE • Now you’re ready to install the wheels. We suggest having one locking wheel on each base foot.
- Page 5 STEP FOUR • Clip the two bottom poles and base feet together until the pin clip clicks into place. STEP FIVE • Unwrap and set aside the two side poles with T-bar base plates. These will connect directly to the base feet. Using two screws and washers for each side, simply attach each side pole •...
- Page 6 STEP FIVE (CONTINUED) • Be sure when positioning the poles to the base feet that the pin clips on each pole are facing inward on the frame and facing each other. STEP SIX • Take the remaining side poles you unwrapped (it doesn’t matter which side pole you use for each connection) and just clip those together their bottom halves already connected.
- Page 7 This might be the easiest part of the entire assembly – grab the two corner connectors and slide them into place on the end of each side pole. • You know it’s in the correct position if you can read (left to right) the Lainly logo imprinted on each connector. STEP EIGHT •...
- Page 8 STEP NINE • Pick either side to start and slide the corner connector into the open end of the top pole. • Congrats on building the frame! Take a minute to admire your work. • Now let’s give it some style.
- Page 9 STEP TEN Hook and Loop Strips and Zippers on the Bottom • Unpack and unwrap the fabric cover. Open the hook and loop strips and zippers on the bottom. STEP ELEVEN • Don’t be intimidated, we designed our fabric to be installed like you are putting on a t-shirt –...
- Page 10 STEP TWELVE • Ensure the semi-circle on each side aligns with the top of each side pole. • Make sure you don’t stand on or put your full weight on the base feet and wheels during this process. STEP THIRTEEN •...
- Page 11 We are here to assist in any way you need us. No matter where you purchased our products, if you have any issues or questions, please reach out to AZ-based Lainly customer service team directly as that will provide you with the best (and fastest) resolution.
Need help?
Do you have a question about the CS1 and is the answer not in the manual?
Questions and answers