Aus Electronics Direct AA6612 Quick Start Manual

No. Description
①
IR receiving window
②
HDMI input indicators
③
HDMI output indicator
HDMI input port switch
④
button
⑤
Power status indicator
No. Description
①
Power jack
②
HDMI output port
③
HDMI input ports
* Please take out the film at the rear of the remote before you use. Please insert the film to remote rear if you do
not use the remote for long time.
Battery Type: CR2025 3V.
Receive the commands sent by the infrared remote control.
The selected input channel indicator will light up.
Lighting when OUTPUT port has signal output.
Short press: Loop to select the INPUT 1-4 channel
Long press: Auto switch function enabled or disabled.
(Enabled by default). When the input channel LED indicator
flash for one time, the auto switch is turned on; when the input
channel LED indicator flash for three times, the auto switch
function is closed.
Lighting when power on.
Requires 5V power supply
Connects to TV/monitor by HDMI cable
Connects to your source device by HDMI cable.
Remote Panel
keys keys
OFF / /
SWITC
ON /
H
SWITC
1 ~ 4
H
AUTO AUTO
SWITC
∧/∨
H
Introduction
Introduction
Functional description
Enable Standby mode
In standby mode, all input indicators are off
Disable Standby mode
Press the SWITCH button to power on in
standby state
Input channel selection
Auto switch function enabled or disabled.
Press the Panel key more than 3 seconds
to enable or disable this function.
Loop to select the INPUT1-4 channel
Supports 4 inputs.