Advertisement

INSTALLATION & MAINTENANCE MANUAL
SHE1BEMS / SHE1GEMS
SHE2BEMS / SHE2GEMS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SHE1BEMS and is the answer not in the manual?

Questions and answers

Summary of Contents for ML Accessories SHE1BEMS

  • Page 1 INSTALLATION & MAINTENANCE MANUAL SHE1BEMS / SHE1GEMS SHE2BEMS / SHE2GEMS...
  • Page 2: General Instructions

    These instructions should be used to aid installation of the following products: SHE1BEMS / SHE1GEMS / SHE2BEMS / SHE2GEMS SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
  • Page 3 • Remove the diffuser by unscrewing the four hex screws at the front of the diffuser • Feed the mains cable through the rubber grommet to retain IP rating, and secure the baseplate to the Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to •...
  • Page 4: Dip Switch Settings

    We recommend, on commissioning the installation, a minimum charge period of 24 hou • carrying out an emergency duration test SENSOR DIP SWITCH LAYOUT SENSOR DIP SWITCH LAYOUT DIP SWITCH SETTINGS DIP SWITCH SETTINGS DIP SWITCH SETTINGS...
  • Page 5 WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. This product is not suitable for installation in or near a coastal or marine environment.
  • Page 6: Warranty

    If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not...
  • Page 7 TESTING FOR EMERGENCY LUMINAIRES Recommended routine test procedure in accordance with BS5266 • Daily check – check LED charge indicator is illuminated • Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation of key switch or switching off circuit breaker.
  • Page 8 230V 50Hz, IP65, Class I, Non-Dim, Ta -20~50...
  • Page 9 INTERNAT CONTACT D INTERNATIONAL CONTACT DETAILS -20°C~ 50°C ML Accessories Limited LU5 4LT www.mlaccessories.co.uk AVOCT21_V2...

This manual is also suitable for:

She1gemsShe2bemsShe2gems

Table of Contents