1. Manuals
  2. Brands
  3. Roll-X Manuals
  4. Laminator
  5. GO
  6. Installation manual

Roll-X GO Installation Manual

Hide thumbs

Advertisement

Table of Contents

ROLL-X GO
ROLL-X GO INSTALLATION MANUAL -
FACTORY ASSEMBLED 2018

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GO and is the answer not in the manual?

Questions and answers

Summary of Contents for Roll-X GO

  • Page 1 ROLL-X GO ROLL-X GO INSTALLATION MANUAL - FACTORY ASSEMBLED 2018...
  • Page 2 INSTALLATION MANUAL ROLL-X 327 / 175 GO ROLL-X 400 / 175 GO ROLL-X 470 / 175 GO ASSEMBLY TYPE: FACTORY ASSEMBLED...

  • Page 3: Table Of Contents

    CONTENT TABLE OF CONTENTS ROLL-X OVERVIEW…………………………………………….. 3 - 3 ROLL-X LEVELING SCREWS…………………………………..4 - 4 ROLL-X CONTROL PANEL……………………………………..5 - 5 ROLL-X COMPRESSOR OR OWN…………………………..5 - 5 ROLL-X TILT FUNCTION………………………………………. 6 - 7 MOUNT ROLL-X ROLL HOLDER GLIDE BEAM………..8 - 8...

  • Page 4: Roll-X Overview

    OVERVIEW This installation manual contains general information when you choosing a factory assembled ROLL-X GO machine. Overview...

  • Page 5: Roll-X Leveling Screws

    ROLL-X LEVELING SCREW After you have unpacked the machine and liftit of the pallet remove the wooden table top lifters. When you have get the table in position screw down every machine foot in disired height, make sure that the table is in level .

  • Page 6: Roll-X Control Panel

    Connect the power cord in to the power socket. Press the power switch button to one. If you purchased a ROLL-X compressor connect to the compressor outlet. Use the air pressure regulator to increase or decrease the pressure of the glide beam roller.

  • Page 7: Roll-X Tilt Function

    ROLL-X TILT FUNCTION If you have purchased the ROLL-X machine with tilt funktion, start by removing the screw with the hanging label. Repeat in the other end of the table. Before you start to tilt the table loosen the plastic knob a little bit behind the bed end cover.
  • Page 8 ROLL-X TILT FUNCTION After you loosen the plastic knob on both sides of the table. Pull the locking handle outwards and twist a quarter turn (left or right) to activate the self holding position of the locking handle. Repeat same step on the other side of the table.

  • Page 9: Mount Roll-X Roll Holder Glide Beam

    MOUNT ROLL-X HOLDERS GLIDE BEAM Mount the roll holders on the glide beam on both sides of the glide beam.
  • Page 10 HEADQUARTERS ROLL-X®. Induflex AB Frögatan 3 SE 653 43 Karlstad, SWEDEN Phone: +46 54 770 70 30 NORTH AMERICAN SALES OFFICE: ROLLSROLLER Enterprise 6345 Netherhart Rd, Unit 1 Mississauga, Ontario L5T 1B8 Canada Office Phone; 905-670-3130 HONG KONG SALES OFFICE: ROLLSROLLER Asia Ltd.

This manual is also suitable for:

327 go175 go400 go470 go

Table of Contents