starlight CR1R Instructions

1
Looking at the keypad,
slide the dark lens cover
away from you (STEP 1)
and lift the lid from the back
(STEP 2).

No Setup required for ANY Samsung, LG or RCA* TV's

FOR ALL OTHER TV BRANDS, FOLLOW THE ONE-TOUCH SETUP INSTRUCTIONS BELOW

With the TV ON, point the remote at the TVs front panel. (Note: For best results, stand at least 5 feet from the TV)
Press and firmly hold down the SETUP button. Do not release. The LED on the remote will blink once and then
after 7 seconds begin searching for your TV's code. The LED on the remote will blink every few seconds as it
searches. The moment your TV shuts OFF, release the SETUP button to lock in the code.

TESTING THE REMOTE:

TV Only
TV + Cable Box
If you accidentally passed the code for you TV model or intend to use the remote on a different TV
Important:
brand, RESET the remote and then follow the one-touch setup instructions above.
RESET: Press and hold the SETUP and CC buttons down simultaneously until the LED on the remote blinks 3
times, then release both buttons. Your remote is now reset.
Copyright© 2022, Starlight Electronics LLC, Command In Hand Inc.
INSTRUCTIONS FOR CR1R AND CR3BCB

BATTERY INSTALLATION

2
Install 2 AAA batteries.
Make sure the + and -
symbols on the metal
hinge of the battery
compartment correspond
with the + and - end of
each battery.
Test power, volume, and channel functions. If all work correctly, setup is complete. If not,
you may not have an exact code match for your TV model. Repeat the search process
(above) to advance to the next code for your TV brand and retest the remote.
Test power and volume functions, DO NOT CHANGE CHANNELS. If these functions
operate correctly, please turn to Page 2.

TROUBLESHOOTING TV CODE SETTINGS

3
With the keypad facing
away from you, close the
cover by gently pressing it
down (STEP 1) and sliding
it until it aligns with the front
(keypad) of the device
(STEP 2).
PAGE 1
4
Test The Remote by
pressing the power button.
The LED should light up,
indicating the batteries are
in correctly. If the LED fails
to light up, the batteries are
either incorrectly inserted or
dead.
Notice:
The optional screw for the
battery compartment is
taped to the box lid.
Take care not to
discard with packaging.
*
RCA Commercial TVs Only
rev.08-09-2022