inventum VMN-47LM54 Installation And Operation Instruction

Installation and operation instructions
VMN-47LM54 - RF-Switch
(3 modes + auto)
A: Away
B: Home
C: Timer
1. How to use this manual
This manual is intended as a reference book by which
qualified installers can install the VMN-47LM54 (RF-Switch
henceforth called "switch") and users can use the switch for its
intended purpose. Make sure you have read and understood
the manual before you install and/or use the
1.1 Intended use
The switch is designed for the purpose to set the level of
ventilation through the fan speed, based on user input. Every
other or further use is not in conformance with the intended
use.
1.2 Working principle
The switch communicates with the control device using
wireless communications, to control the ventilation.
When you press a button, the switch sends this information
to the ventilation system. The ventilation system processes
this request and sends the resulting status back to the
switch. The switch shows the resulting status on the LED.
The ventilation system drives the fan based on the highest of
values sent by the bound wireless sensor(s).
1.2.1 Ventilation speeds and modes
The ventilation system runs in one of the following modes. In
each of these modes, the switch sets the ventilation system
to a configured level of ventilation.
Mode
Away
Home
Timer
Auto
AUTO
The ventilation system drives the fan based on the highest of
values sent by the bound wireless sensor(s).
You can start the timer mode from this switch for 30, 60 or
90 minutes.
D: Auto
E: Status led
switch.
Fan speed
Low fan speed
Medium fan speed
High fan speed, for a
restricted duration
Between low and high fan
speed, based on measured
values
1.3 Admonitions
Warning' identifies a hazard that could lead to
'
personal injury, including death.
'Note' is used to highlight additional information.
2. Content delivery
• RF-Switch (3 modes + auto) (VMN-47LM54)
• Battery
• Mounting screws
• Mounting plugs
• Manual
3. Safety
The switch meets the following EC
•
EMC directive:
•
Low voltage directive:
•
RTTE directive:
•
RoHS directive:
•
WEEE directive:
3.1 Signs on the switch
CE-marking of conformity.
Dispose according to European Community
Directive 2012/19/EU (WEEE).
General safety instructions
The switch is designed for indoor use only. Do not
expose the switch to rain or moisture, to avoid short
circuit. Short circuit may cause fire or electric shock
hazard. Operate the switch between 0°C and 40°C. For
cleaning of the switch use a soft damp cloth only. Never
use any abrasive or chemical cleaner. Do not paint the
switch.
4.Visual signals
Start up
Status
OK
Battery Low
Fan error
Interaction response
Mode changed
Binding succeeded
Communication
error
directives:
2014/30/EC
2014/35/EU
2014/53/EU
2011/65/EU
2012/19/EU
Status LED
Orange 1 flash
Green
Orange 1 flash
Red 2 flashes
Green 1 flash
2 flashes
Red 1 flash
1
1
2
2
1