Velocity ZT-DVS-RM/B Manual

Description
The ZT-DVS-RM/B is a remote microphone for use with the ZT-MNS-100BAS Series Voice Evacuation panel.
Only one remote microphone can be used with each audio panel. (Note the 100BAS panel includes a
microphone.)
The ZT-DVS-RM/B microphone can be located up to 100 feet from the ZT-MNS-100BAS to provide paging
and live 'override' of the pre-recorded message and alert tones.
The microphone and interconnecting wires are supervised. A fault will cause the Control Board's System
LED, and the Remote Mic Fault LED to light.
The surface mounting steel enclosure includes a key locking hinged cover. The device can be placed in an
entry way for access by authorized personnel only. The 3-1/2" depth of the box complies with ADA
guidelines. Note the enclosure can be custom semi-flush mounted on-site.
Specifications
Input: Volt / Amp: 24 VDC / 0.06A
Output: Compatible with the VDOT-MNS-100BAS
Wiring: Up to 100 feet
18 to 22 AWG, 4-conductor cable Shielding
recommended, if cable is run in same conduit
with SLC
Size: 7.25"W x 8.25"H x 3.5"D; 18.4 x 21 x 8.9 cm
Color: Red
Installation
The location of the remote microphone is determined by the system requirements. Acoustic coupling of the
microphone and a local speaker must be considered. Do not place directly below, or in front of the local
speaker. It is preferential that they be separated by 10 feet or more.
The ZT-MNS-RM/B surface mount metal box has four mounting holes in the back. To access the mounting
holes and the wiring connections, loosen the thumbscrew at the top of the front plate and remove the
entire dead front panel.
www.velocitydetection.com Doc: GLT-322-7-23
Remote Microphone
Issue: 002
ZT-DVS-RM/B
Date: 16/11/2021