Rhino-Rack RBCA030 Quick Start Manual

RBCA030 Axle Adaptor including 15 x 100mm Insert.
Important: Please read these instructions carefully prior to installation.
Please refer to your fi tting instruction to ensure that the Roof Rack System is installed in the
correct location.
Check the contents of kit before commencing fi tment and report any discrepancies.
Place these instructions in the vehicle's glove box after installation is complete.
Note: For use with
Rhino-Rack Road Warrior
RBC036
Rhino-Rack Mountain Trail
RBC035
Rhino-Rack SQR RBC011
1. Check Part No./Kit is correct
2. Read through instruction before installing 4.
Maximum carrying capacity: 15kg/33lbs bicycle
Recommendations: For use with Rhino-Rack Road Warrior and Mountain Trail Bike Carriers and SQR.
It is essential that all bolt connections be checked after driving a short distance when you fi rst install your bike rack. Bolt
connections should be checked again at regular intervals (probably once a week is enough, depending on road conditions, usage,
loads and distances travelled).
Bike Carrier is not suitable for Tandem bikes, E-bikes, recumbents.
Remove front fenders, child seats & panniers before use.
Warning: Locks are only a deterrent. Please exercise care when protecting your items from theft.
Sensitivity to cross winds, behaviour in curves and braking.
The handling characteristics of the vehicle, changes when you transport a load. For safety reasons, we recommend you exercise
extreme care when transporting wind-resisting loads; special consideration must be taken into account when braking.
Please remove bike rack when putting vehicle through an automatic car wash.
Load Ratings:
Maximum permissible load is 15kg/33lbs.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
These instructions remain the property of Rhino-Rack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Important Information
3. Fit roof rack accessory
Check and recheck all fasteners are secure
Document No: R906
Prepared By: Kayle Everett
Authorised By: Chris Murty
CONTROLLED
Fit TIme: 10min
Issue No: 03
Issue Date: 28/12/2016
Page 1 of 3