Page 2
Thank you for choosing our BNR6502 Electric Mixer This manual covers the proper operation and maintenance. Before operating, please read this manual carefully for im- portant procedures and safety. All technical data and drawings in this manual are consistent with the information on this product. As a result of revisions and other on going updates, the contents of this manual may be slightly different from the actual product.
Page 3
PLEASE NOTE Always check to see if voltage corresponds with the manufacturer’s requirements Our mixers are double-insulated in accordance with EN60745; therefore, a ground wire is not required. USE PROPER EXTENSION CORD: Only use an approved extension cable that is suitable..for the machine’s power. Page | 3 BN Products-USA www.bnproducts.com...
Page 4
Damaged or entangled cords increase the risk of electric shock. • When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Page | 4 BN Products-USA www.bnproducts.com...
Page 5
• Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired be- Page | 5 www.bnproducts.com BN Products-USA...
Page 6
We recommend that you always wear industrial safety gloves and safe- ty goggles when working with the mixer. • Wearing close-fitting clothes is mandatory. • Always allow for reaction torque • Always wear a dust mask Page | 6 BN Products-USA www.bnproducts.com...
Page 7
The switch position enables you to work at high or low speeds. The gear switch position should only be changed when the unit is stopped in order to prevent the gearing from being damaged. 1st gear - I 2nd gear- II Page | 7 BN Products-USA www.bnproducts.com...
Page 8
Do not replace one side without replacing the other. Reassemble using the new brush assemblies. Make sure that the brushes move freely in the brush tube. Replace the brush cap and tighten it secure- ly. Do not over tighten. Page | 8 BN Products-USA www.bnproducts.com...
Page 9
For your own safety, never remove parts or accessories of the electric tool during operation, In case of fault or damage have the electric tool repaired only by a specialist workshop or by the manufacturer. Page | 9 BN Products-USA www.bnproducts.com...
Page 10
• 12’ power cord. • Standard M27 paddle connection. • Includes two general purpose mixing paddles (22.44” x 4.33”). Item No. BNR6502 Double Paddle Mixer Rated Voltage 120V - 60HZ Rated Power 1800W (15A) Rated No-Load Speed I: 200-400 rpm II: 350-700 rpm Mixing Paddles Dia.
Need help?
Do you have a question about the BNR6502 and is the answer not in the manual?
Questions and answers