Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for WARRIOR GENERATORS LDG12S
- Page 1 WARRIOR GENERATORS USER MANUAL FOR MODELS: LDG12S & LDG12S3...
-
Page 2: Table Of Contents
CONTENT 1. Safety Instructions 2. Specifications 3. Components of Generator Set DG12 Components DG12S Components 4. Preparation Before Start DG12 Check Before Operation DG12S Check Before Operation 5. Operation 6. Stopping Generator 7. Maintenance DG12 Check and Maintenance DG12S Check and Maintenance 8. -
Page 3: Safety Instructions
1. Safety Instructions Notes: Please read this manual carefully and make sure you fully understand, to avoid serious damage to user or product. • Careful inspection required before starting generator each time. • In order to prevent fire disaster and keep the generator set in a well ventilation area, please keep the generator set at least 1 metre from any objects. -
Page 4: Specifications
2. Specifications DG12(Open frame) DG12S(Silent) Model DG12 DG12-3 DG12S DG12S-3 Engine model 290F Type Air cooled, 4-stroke, Twin-cylinder Bore Speed 3000/3600 Max output Starting system Electric start Brush/Brushless, Brush, Brush/Brushless, Brush, Type AC three phase AC three phase AC single phase AC single phase Frequency 50/60... -
Page 5: Dg12 Components
3. Generator Set Assembly Components DG12 Components Description Quantity Item Top cover Frame Engine side cover Front cover Muffler assy Air cleaner assy Engine Shock absorber Lock wheel Alternator Wheel Control panel Battery Motor side cover Fuel tank Back cover... -
Page 6: Dg12S Components
DG12S Components Description Quantity Description Quantity Item Item Control gate Muffler assyⅡ Control panel Shock absorber Battery boards Battery Front cover Inner cover Left door Air cover Upper plate Back cover Rubbe rcover Bottom seat Alternator clapboard Fuel tank Alternator Wheel Muffler heat Lock wheel... -
Page 7: Dg12 Check Before Operation
4. Inspection Before Operation DG12 Check Before Operation 1. Oil level Notice: Check oil level before operation each time. ① Opening lock button, and then raise upper cover. ② Loosen oil dipstick, clean it with cloth, UPPER LIMIT and then insert into filter neck (do not LOWER LIMIT screw). -
Page 8: Dg12S Check Before Operation
DG12S Check Before Operation 1. Oil level Notice: Check oil level before operation each time. ① Open right door, You will see the oil dip stick. ② Loosen oil dipstick, remove clean it with cloth, and then insert into filter neck (do not screw). Add OPEN engine oil if it is below the minimum level, ways of adding oil as below in (7.1.①), Finally, install and... -
Page 9: Operation
5. Operation Single Phase Control Panel Three Phase Control Panel Starter switch AC circuit breaker Starter switch AC circuit breaker OF F OF F OIL A LE R T P OWE R V OL T ME TE R BR EA K ER BR EA K ER OIL A LE R T P OW E R V OL TM E TE R... - Page 10 7. Maintenance and Remedy of Generator Set Notice: Proper maintenance is not only the basis of safe, economical and easy way of generator operation, but also helpful to reduce the air pollution. Warning: If the maintenance instructions are not followed properly, it may cause serious personal injury.
-
Page 11: Maintenance
DG12 Maintenance 1. Change the oil ① Please prepare the oil container under the drain plug, use the fork to release the drain plug, then begin to pull out the oil, when the oil pull over, if necessary, use the diesel to clean the inside of the cylinder block. In the end lock the drain plug back. -
Page 12: Dg12S Check And Maintenance
DG12S Maintenance 1. Change the oil ① Open left door, use the fork to release the drain plug (don't take out screw), put the oil guide groove under the drain plug, let its outlet connect with oil container, then completely remove the oil drain plug. Begin to release out the oil and when the oil sump is empty, if necessary, use the diesel to clean the inside of the cylinder block. -
Page 13: Appendix And Suggestion
8. Appendix and Suggestions 1. Storage It is necessary to store the generator in correct way to keep generator in good condition. Following steps are to protect the generator from rust and corrosion which would damage its performance and appearance. ①... -
Page 14: Urgent Problem Solution
9. Methods of Unexpected Problem Remedy Generator can't start Cause Bad connections of Check each connector current line Check the power control system 1. Charge the battery Battery power is low 2. Change the battery Without fuel Add fuel Check fuel and Without oil Add oil machine oil... -
Page 15: Electrical Wiring Diagram (Single Phase)
10. Electrical Wiring Diagram (Single Phase Generator) 11. Electrical Wiring Diagram (Three Phase Generator) -13-...