Laser 6734 Quick Start Manual

Changing the Oil
1. Note: It is recommended to change the hydraulic oil once per year.
2. Lay the jack on its side and drain the fluid into a suitable container.
3. Dispose of used oil following local authority guidelines.
4. Refill until oil level is 4mm above the inner cylinder as seen from the oil filler hole.
5. Refer to "First Use" section above and follow the instructions to purge the
hydraulic system to eliminate any trapped air in the system.
6. Check oil level again and top up if necessary.
Keep the jack clean and dirt-free. Regularly check the hydraulic ram and
mechanism for signs of dirt and/or corrosion. Clean as necessary and ensure that
no abrasive materials are used near the hydraulic ram.
Precautions
Our products are designed to be used correctly and with care for the purpose for which they are intended. No liability
is accepted by the Tool Connection for incorrect use of any of our products, and the Tool Connection cannot be held
responsible for any damage to personnel, property or equipment when using the tools. Incorrect use will also invalidate
the warranty.
If applicable, the applications database and any instructional information provided has been designed to offer general
guidance for a particular tool's use and while all attention is given to the accuracy of the data no project should be
attempted without referring first to the manufacturer's technical documentation (workshop or instruction manual) or the
use of a recognised authority such as Autodata.
It is our policy to continually improve our products and thus we reserve the right to alter specifications and components
without prior notice. It is the responsibility of the user to ensure the suitability of the tools and information prior to their use.
Guarantee
If this product fails through faulty materials or workmanship, contact our
service department direct on: +44 (0) 1926 818186. Normal wear and tear
are excluded as are consumable items and abuse.
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DR
T +44 (0) 1926 815000 F +44 (0) 1926 815888
info@toolconnection.co.uk www.toolconnection.co.uk
www.lasertools.co.uk
Low Profile Jack
3 Tonne
• Twin pump design for faster lift.
• Minimum height 85mm, maximum height 500mm.
• Size: 690mm x 343mm x 149mm.
• Weight 34kgs.
• Conforms to EN1494:2000.
www.lasertools.co.uk
6734