Brief introduction to buttons on top panel Power Button: Press and hold button for 3 seconds to power on or power off speaker Volume Control: Volume Control: Increase volume Decrease volume Previous song Next song Light Button: Bass Button: Briefly press to turn on/off the light Briefly press to switch bass mode, mode and switch the light modes, total 3 modes.
BT button, the speaker will disconnect from its paired device. A different device can now be paired. Party-sync with AL SHOCKWAVE Family AL Shockwave A double press of the BT button is used to enter/exit party-sync mode on extra speakers if you have them as below.
The Altec Lansing SHOCKWAVE family has four members that support party-sync. You can mix and match between any of these four models, setting up one speaker as the primary unit connected to up to 100 other speakers all playing in sync.
INPUT/OUTPUT PORTS Descriptions about the various ports on the speaker AUX: For line level or headphone output from audio sources RESET: USB OUT: Button is recessed inside. For use only in the For charging your mobile devices unlikely case of a lock up. Use paperclip or pin to perform restart of the speaker.
Page 8
Supplier's Declaration of Conformity 47 CFR § 2.1077 Compliance Information Unique Identifier Trade Name: Altec Lansing Model No.: IMT7000 Responsible Party – U.S. Contact Information US Company Name: SAKAR INTERNATIONAL INC. Address: Edison, NJ 08817 Telephone number or internet contact information: 855-292-4087...
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions – All the safety and operating instructions should be read before this product is operated. 2.Keep these instructions – The safety and operating instructions should be retained for future reference. 3.Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.
Page 11
ATTENTION: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR - This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Need help?
Do you have a question about the IMT7000 and is the answer not in the manual?
Questions and answers