Advertisement
Quick Links
Advertisement
Summary of Contents for SAFESTOR Skipton SFSM001
- Page 1 Skipton Bike Locker SELF ASSEMBLY INSTRUCTIONS SFSm001 www.spearheadbikes.co.uk...
- Page 2 USI 026 21-04-2016 Before Assembly It is important you have a level firm YOU WILL NEED base for your unit. This should be constructed from concrete, tarmac or flags and be a minimum of 50mm Recommended: (1.9”) deep. Powerdriver Stor Measurement Silicone Sealant 1012mm x 2055mm (40”...
- Page 3 step by step step 1 step 2 X 18 Position Front RH (right hand) side panel 7 into the groove on the Base Position Rear RH (right hand) side panel 3 into the groove on the base panel panel 1 ensuring the holes are aligned. 1 and the already fixed Front RH (right hand) side panel 7 , ensure the holes are aligned and screw together.
- Page 4 step by step step 5 step 6 X 18 X 18 Position Back panel 5 into the groove on the base panel 1 , between the Position Front LH side panel 6 into the groove on the base panel 1 and side panels 2 and 3 , and under the Back Fascia panel 4 .
- Page 5 step by step step 9 X 12 Support the door at all times whilst fitting the counter sunk screws 16 to ensure correct alignment, always use a hand held screwdriver. Position the Door 10 so that the hinges are aligned with the fixing holes, screw together. step 10 step 11 Finally slot the Wooden flooring 13 into place ensuring that the cut out is...