Page 1
Documentation Center Installation Guide Assembly List Figure 1: Assembly list Assembly Step 1: Install the plate with two M4*5 screws. Figure 2: Installing the Plate Step 2: Fix the WisBlock IO module with three M1.2*3 screws; For assembly method and precautions, please refer to RAK5005-O Baseboard Installation Guide..
Page 2
Documentation Center Figure 4: Attaching WisBlock Module Step 4: If an external connection is required, for example an external sensor, remove the plug on the longer side of the enclosure and replace it with the gland. Pull the cable to the external device through the gland and make sure the lid of the gland is closed properly.
Page 3
Documentation Center Figure 7: Installing standoff screws Step 7: Plug the battery cable into the socket on the PCB (if the solar panel enclosure is used, connect the cable of solar panel to the PCB), and then fix the battery plate on the standoff with two M2.5*4 screws. WARNING ⚠...
Documentation Center Figure 10: Attaching the Cover Installation Wall Mounting Step 1: Fix the installation kit on the bottom of the enclosure with four M5*10 screws. Make sure that the Z-shaped mounting bars are extruding from the enclosure as shown in the image. Figure 11: Installing the Bracket Step 2: Using a Ø5mm drill bit, drill 4 holes on the wall according to the dimension of the following picture and then plug the screw anchors in the wall.
Documentation Center Figure 13: Attaching the Enclosure to the Wall Pole Mounting Step 1: Fix the installation kit on the bottom of the enclosure with four M5*10 screws. Make sure that the Z-shaped mounting bars are NOT extruding the enclosure, as shown in the image. Figure 14: Attaching the Installation Kit Step 2: Slide the Steel band clamp through the rectangular hole of the mounting bar, wrap the band clamps around the pole, lock them and then tighten the clamps using a screwdriver.