Smarthome WC815L Instructions

Instructions for Chime Wireless ( Model no.WC815L, WC532L, WC533L,
WC805L)
1. Use a small screwdriver to open the cover of transmitter. Insert the supplied 1pc 3V
CR2032 button cell with positive (+) up, observe polarity.
2. Locate a good position for the pushbutton next to the door. Do not mount on or next to a
metal surface. Drill two 4.76mm holes and insert the wall plugs. Place the back plate in the
right position and tighten the plate on wall with the screws (2.6 x 26mm BA type) supplied.
Close the cover.
3. Open the battery door of chime receiver, insert 3pcs 1.5V "D" cell battery in the chime,
observe polarity.
4. Press "Learn" button ( symbol
it indicates the receiver is in learn mode process.
5. Press the transmitter once, and you will hear the melody from chime receiver. This
indicates the receiver is learning the signal from transmitter properly. Press the transmitter
to hear the built-in melodies in the receiver. Stop pressing the transmitter when you hear
the desire melody. There are total 16 different melodies for selection.
- Westminster
- Ding Dong
- Ding Dong Ding
- Tubular 1
- Orchestra
- Tubular 2
- Trumpet
- Dog Barking
- Mirage
- Bird
- Pang
- So me do
- Knock Knock
- Cuckoo
- Old phone
- Buzzer
6. After that, press again "learn" button on the receiver, the LED light off and the receiver exit
the learn mode.
Or, just wait approx. 20secs, the LED light off and the receiver will exit the learn mode
automatically.
) once on receiver (see fig.1). The LED light up,