Advertisement
7-5. Preparation for Adjustment
(1) As above Fig. 3, Connect the Set, EDID Download Jig,,
PC & Cable
(2) Turn on the PC & EDID Download Jig. And Execute the
S/W : EDID TESTER Ver.2.5
(3) Set up the S/W option
Repeat Number : 5
Device Address : A0
PageByte : 8
(4) Power on the Set
1) Sequence of Adjustment
1. DDC data of Analog-RGB
(1) Init the data
(2) Load the EDID data.(Open File).
Open File
(3) Set the S/W as below.
Copyright©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
[Analog - RGB
: PP81A_RGB.ANA]
[Digital - HDMI1 : PP81A_HDMI1.DVI]
[Digital - HDMI2 : PP81A_HDMI2.DVI]
[Digital - HDMI3 : PP81A_HDMI3.DVI]
(4) Push the "Write Data & Verify" button. And confirm "Yes".
(5) If the writing is finished, you will see the "OK" message.
8. HDCP
(High-Bandwidth Digital Contents Protection)
(1) Connect D-sub Signal Cable to D-Sub Jack
(2) Input HDCP key with HDCP-key- in-program
(3) HDCP Key value is stored on Main M-STAR
IC(LGE6891DD) which is 0x80~0x90 addresses of
0x00~0x01 page(EEPROM MAP PAGE0~PAGE1 /
START :A080)
(4) Play the Equipment(DVD Player) included HDCP Key and
confirm whether picture is displayed or not of using DVD
Player.
(5) HDCP Key value is different among the sets
- 10 -
LGE Internal Use Only
Advertisement
