General Cleaning (To Be Performed By Store Personnel) - Exterior / Interior - Oasis FSC663R User Manual

GENERAL CLEANING (TO BE PERFORMED BY STORE PERSONNEL) - EXTERIOR / INTERIOR

FREQ.
Daily Deck/Rear Plenums: Clean with a warm soap and water solution. For stubborn stains and
residue, TURN MAIN POWER SWITCH OFF. Remove deck and clean with soap and water
solution or submersed in hot, soapy water solution. Rinse thoroughly. Dry. Return to case.
Turn main power switch back on.
Daily Glass Surfaces (Sides): Clean with household or commercial glass cleaner.
Weekly Shelving/Bracket Assemblies
 Wipe off shelf/bracket assemblies with moist cloth.
 Brackets and shelving CAN BE removed for more thorough cleaning. Caution! Removal
of shelving/bracket assemblies should ONLY be performed when stubborn stains or
residue CANNOT be removed with shelving/bracket assemblies remaining on case.
 To remove shelf/bracket assembly, simply lift upward and out.
 Caution: As LED lighting is attached to underside of shelving, you must disconnect LED
wire from its connectors. Due to the electrical components, DO NOT submerse shelving/
bracket assemblies while cleaning.
 Clean with mild soap and water solution and a non-abrasive soft cloth. For stubborn
stains use a nylon brush. DO NOT use abrasive cleaners or Brillo® pads, as these can
destroy the shelf/bracket finish.
 Caution! After removing and cleaning shelving/bracket assemblies YOU MUST return
them to THE SAME EXACT slots they were in prior to their removal.
 Reconnect connectors into LED plugs after shelving/bracket assemblies are in place.
Weekly Side Panels All Around (and Upper Fascia): Clean with mild soap and water solution and a
non-abrasive soft cloth.
Weekly Acrylic Air Deflectors: Clean with warm water, mild soap solution and soft cloth; acrylic
cleaning solutions are also available. Caution! Never use ammonia-based cleaners on
acrylic. Incorrect cleaning agents or abrasive cleaning cloths cause surface to 'cloud' over
time.
Weekly Condenser Coil: Vacuum or brush grille condenser coil at case front. Use metal or fiber
brush to remove dust and dirt that can collect on condenser coils. Be careful not to damage
the fins on the coil. See REFRIGERATION FUNDAMENTALS: CONDENSATE PACKAGE
ACCESS section in this manual for instructions on side panel removal.
Monthly Under Case Cleaning: Remove front (or rear) panels. Vacuum under case to remove all dust
and dirt. Replace front (or rear) panels when complete.
AREA / INSTRUCTIONS
16