Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AccuDual ACD-10300
- Page 1 ACD-10300 User Guide v1.1...
-
Page 2: Table Of Contents
Specification ............................1 Overview ..............................2 Front and rear view of touch-panel box: ....................2 Function description ..........................3 Installation of ACD-10300 ........................4 Installing ACD-10300 to system ......................4 Front-side operation instructions: ...................... 5 Instructions of setting active zone: ..................... 6... -
Page 3: Package Insides
Package Insides ACD-10300 box AC to DC Power adapter AC Power Code Mouse Specification AC power input 100V~240V Net Weight:0.41 Kg Gross Weight: 0.8 Kg Bare product Dimension:115*83*28 mm Packing Dimension: 145*225*80 mm Work temperature: Celsius 5 ~ 45 degrees... -
Page 4: Overview
Overview ACD-10300 is a distinctive design for working with the optical mouse to replace light pen on AMAT 200 mm semiconductor systems, such as Centura 5200, P5000 and Endura 5500 systems. No driver needed and no configuration changed on system. Just few simple plug-and-play steps, then switch to mouse-control smoothly and easily, and still compatible with CRT’s function. -
Page 5: Function Description
LED lit to indicate setting mode. 3. USB port for mouse: ACD-10300 supports any USB interface optical mouse. 4. 25 pin D type input: DB-25 type, for Receiving the VGA signal from AMAT system. -
Page 6: Installation Of Acd-10300
Installation of ACD-10300 Installing ACD-10300 to system Just follow the instructions listed below to connect cables and execute simple procedures, then you can start using mouse to control system. 1. Remove the DB25 cable from CRT then connect to DB25 and secure the screws. -
Page 7: Front-Side Operation Instructions
Front-side operation instructions: 1. Plug in the optical mouse to USB port. 2. Press Power button to turn on power of the box. 3. Press and hold Setting button for over 2 seconds then release to enter “setting mode” for setting active zone of monitor, the instructions shown as below figures. -
Page 8: Instructions Of Setting Active Zone
Instructions of setting active zone: 1.Move 1. When switch to setting mode, the screen will be shown as Fig.1.Use mouse to move the cross point of horizontal and vertical line to upper-left edge of the screen as close as you can, Fig-1 but the cursor must be visible on the screen, do not move it out... - Page 9 Fig.4 Fig-4 PS. During your operation of the ACD-10300, if you feel too slow of the mouse cursor movement then you can try to adjust the cursor sensitivity by quick clicking of the setting button, you can keep doing this till you are happy with...