S-5! ProteaBracket Install Instruction

Installation Instructions
Attention! This document is a guide only. This product may not be suitable for every application. The
user is responsible for all necessary applications engineering and design. Please scan the QR code to the
right for additional information, warnings and disclaimers regarding product use.
You can also view load test results at www.s-5.com where applicable, or contact your S-5! distributor for
more information.
These instructions are for use by those experienced in the trade. Always follow appropriate safety precautions and use appropriate tools.
What's Included in Your Box
• (100) pre-assembled ProteaBrackets*
• (401) stainless steel capped self-piercing screws*
*Broken-box quantities may vary
ProteaBracket is designed to fit most trapezoidal sheet shapes.
Caution is advised for rail-mounted PV installations in snow country.
What You'll Need for Installation
• String line
• Rag
• Screw Gun
• 5/16" (7,7 mm) Drive Socket
• 1/2" (13 mm) Open-end (Spanner) or Socket Wrench
When installing the PVKIT as illustrated in Fig. B, an extra M8 nut is needed. (Purchase separately.)
Are You Mounting With PVKIT
For Use With
Side-Mounted Rails:
ProteaBracket comes pre-assembled
in the correct orientation for use with
side-mounted rails. If the assembly
has been deconstructed, orient the
L-foot as shown in Fig. A.
Use Proper Hardware
ProteaBracket is mounted directly onto the crown of the trapezoidal
sheet using the stainless steel cap screws (provided) or Bulb-Tite
rivets (not provided).
Provided
Screw Specifications:
1/4" (6.3 mm) Diameter - 1" (25 mm) Length
- 5/16" (8 mm) Hex head with EPDM rubber
sealing washer
The Right Way to attach almost anything to metal roofs!
™
®
Fig. A
For the PVKIT or Bottom-
Mounted Rails:
Remove the M8 nut and orient
the ProteaBracket's L-foot as
shown in Fig. B to mount the
PVKIT or bottom-mounted rails.
Not Provided
Rivet Specifications:
9/32" (7.7 mm) Diameter - Alu/Alu Flat Head
Bulb-Tite Rivet with 5/8" (16 mm) EPDM
Washer Grip: 0.032" / 0.8 mm - 9.5 mm
Components
ProteaBracket
(Pre-assembled)
Stainless Steel
Capped
Self-Piercing
Screws
or Using Rails?
Fig. B
1
Diagram illustrates L-Foot
in rail-mount position