CPI ACM-125 Installation

INSTALLATION ON A
KEEP STEPS AND LIGHT DRY DURING INSTALLATION
Follow STEP
instructions
for assembly
INSTALLATION ON THE
To be performed by an authorized dealer ONLY
*GASKET SOLD SEPARATELY
IMPORTANT:
LOWER
THE WATER
LEVEL OF
THE POOL
2" diameter hole,
MORE THAN 18"
(45cm) below
normal water level
STEP 1
STEP 1
Using a 2" (50.8mm) cutting devise,
drill a hole through the pool wall and liner.
STEP 1A
Insert the gasket from the inside
of the pool through the 2" hole in the wall,
having the large diameter inside the pool
and the small diameter on the outside.
By: Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
www.champlainplastics.com
ACM-125 & ACM-125C
Universal Pool Light
POOL STEP
and centered
on riser
STEP 1
STEP 1
Using a 2" (50.8mm) cutting
devise, drill a hole in the second riser
from the top at 4-1/2" (114.3mm) from
the top at center.
WALL
Pool Liner
18"+
Large side of
gasket* on
INTERIOR
of pool.
STEP 1A
4-1/2"
from top
of riser
STEP 2
through the hole (as shown).
OF ABOVE-GROUND POOL
Pool wall
Small side of
gasket* on
EXTERIOR
of pool.
STEP 2
Thread the electrical cord
STEP 2
STEP 2
Thread the electrical
cord through the hole (as
shown).
INS-ACM125-rev3E
09-2019