CPI ACM-125 Installation page 2

INSTALLATION
Underside of pool step or
exterior wall of pool
• Risk of electrical shock, if instructions are not followed. Connect only to a
grounded GFCI outlet that is a minimum of 10 feet (3 m) away from the pool.
DO NOT USE EXTENSION CORDS.
• Do not let children use this device unsupervised.
• For use on permanent above-ground pools only.
• Do not use the light if the lens, transformer or cord is damaged.
WINTER STORAGE: Freezing weather may damage light fixture. Disconnect
light and remove from the pool. Store in dry space at room temperature.
By: Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
www.champlainplastics.com
ACM-125 & ACM-125C
Universal Pool Light
POOL STEP
:
(cont'd)
STEP 3
STEP 6
(Step installation only) Install steps
in pool (follow STEPS Instructions).
Attach the electrical cord to the step.
STEP 7
is out of the water. Slide plastic O-ring
(B) onto transformer plug. Insert pins
into transformer outlet and secure with
STEP 6
cap. The transformer should be plugged
into a GFCI outlet.
WARNING
and
STEP 4
STEP 5
Make sure the transformer (A)
Remote Control with Pool Lights
WALL
STEP 3
Insert the plastic
washer.
STEP 4
Secure the light from
behind with the plastic nut. DO
NOT OVER TIGHTEN.
STEP 5
Secure plastic nut
with the safety cap and 2
supplied screws.
(B)
(A)
(A)
STEP 7
NOTE:
Operating and Pairing
instructions included
with ACM-125C only.
INS-ACM125-rev3E
09-2019