Mueller ArmorFlex MG-50G Quick Start Manual

Expandable

Instructions

1.
Before use, ensure rubber gaskets are inserted into the Female Brass
Connector and bottom of Spray Nozzle. These are important to avoid
leaks. 3 Spare gaskets are provided.
2.
Connect Spray Nozzle (with rubber gasket) to Male Brass Connector.
(NOTE: Using a nozzle is recommended to maintain pressure.)
3.
Turn the garden hose Valve to the OFF position (Horizontal position).
4.
Attach the Female Brass Connector (with rubber gasket) to the water
source/spigot.
5.
Gradually turn the water on at spigot and allow the hose to expand to
full length. Do not pull or drag the hose while water is still filling. This
will better protect the hose.
6. Face nozzle where you desire to spray and rotate dial for preferred
Spray Option.
7. Open the brass Valve to ON (Vertical position). Ensure water pressure
at spigot is at full pressure (6 bars recommended). Squeeze Spray
Nozzle Handle to release water. Use Lock for continuous water flow.
8.
When finished, turn the water off at the spigot (or Valve for short-
periods only). Ensure Valve is ON, squeeze Spray Nozzle Handle, and
allow excess water to drain. The hose will retract to its original size.
Garden Hose
Model: MG-50G