en Troubleshooting
Fault
timeLight does not light up.
High spin speed not
reached.
The spin programme does
not start.
Noise
Fault
Rushing, hissing noise.
Loud noises during the spin
cycle.
Banging noises, rattling in
the drain pump.
58
Cause
Energy-saving mode is act-
ive.
A low spin speed is selected.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Cause
Water is flushed under pres-
sure into the detergent
drawer.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Foreign bodies have got into
the drain pump.
troubleshooting
Press any button.
▶
a The symbol lights up again.
The next time you run a wash cycle,
▶
set a higher spin speed.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶
troubleshooting
Not a fault – normal operating
▶
noise.
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
→ "Cleaning the drain pump",
▶
Page 49