JVC GR-D250AA Instructions Manual page 25

The "s SYSTEM" functions which are set when
the Power Switch is set to "M" are also applied
when the Power Switch is set to "PLAY".
[ ] = Factory-preset
BEEP
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
BEEP: The beep sounds when the power is
turned on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. ( pg. 29)
[MELODY]: Instead of a beep, a melody sounds
when any operation is performed. It also
activates the shutter sound effect. (
REMOTE
OFF: Disables the remote control operations.
[ON]: Enables the remote control operations.
It is recommended that this function be set to
"OFF" to prevent improper operation.
DEMO MODE
OFF: Automatic demonstration will not take
place.
[ON]: Demonstrates certain functions such as
Program AE with special effects, etc., and can
be used to confirm how these functions operate.
Demonstration starts in the following cases:
When the Menu Screen is closed after "DEMO
MODE" is turned "ON".
With "DEMO MODE" set to "ON", if there is no
operation for about 3 minutes after the Power
Switch is set to "A" or "M".
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
NOTES:
If a cassette is in the camcorder, the
demonstration cannot be turned on.
"DEMO MODE" remains "ON" even if the
camcorder power is turned off.
If "DEMO MODE" remains "ON", some functions
will not be available. After viewing demo, set to
"OFF".
SYSTEM
pg. 29)
MENUS FOR DETAILED ADJUSTMENT
PRIORITY
[LCD]: The image is displayed on the LCD
monitor when the viewfinder is pulled out while
the LCD monitor is opened.
FINDER: The image is displayed in the
viewfinder when the viewfinder is pulled out
while the LCD monitor is opened.
CAM RESET
EXECUTE: Resets all settings to the factory-
preset.
[RETURN]: Does not reset all settings to the
factory-preset.
25
EN