Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ohmeda Panda
Summary of Contents for Ohmeda Panda
- Page 1 Panda ™ Baby Warmer Operation and Maintenance Manual Approved 2009−6−4 16:13 EET DST Barbara A Hairfield 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
- Page 2 Should such repair or replace- ment become necessary, Ohmeda Medical recommends that a telephone or written request for service advice be made to the nearest Ohmeda Medical Regional Service Center. This Product or any of its parts should not be repaired other than in accordance with written instructions provided by Ohmeda Medical and by Ohmeda Medical trained personnel.
-
Page 3: Table Of Contents
Bed Platform Operation ..............3-11 Side Panel Operation ................. 3-12 Oxygen Administration ............... 3-13 Gas Cylinder Installation and Operation ..........3-14 Mounting Accessories ............... 3-16 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... - Page 4 Accessories ..................A-7 Radiant Energy Distribution ............... A-8 Installing wall mounted units ............... A-9 Pre-Installation Preparation .............. A-10 Warmer Installation ................A-10 Warranty 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
- Page 5 Increase % Power or Control Temperature Decrease % Power or Control Temperature Alarm Silence Alternating Current Do not place an infant on this surface European Union Representative 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
- Page 6 Notes Table of Contents 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
-
Page 7: Warnings
Ohmeda Medical. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... - Page 8 Notes Table of Contents 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
-
Page 9: 1/Description
The control unit contains the electronic circuits and controls used to operate the radiant heater and the observation light. The control unit performs regular self checks during its operation including failure diagnostics. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 10: Bed Platform
Accessories which mount on a single upright are interchangeable between all model Warmers. Accessories can only be mounted to the inside dovetail rail on each upright of the free standing warmer. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 11: Setup
Refer to the setup instructions shipped with the warmer for initial unpacking and setup of the unit after shipment. After removal from the shipping containers, inspect the Ohmeda Panda Baby Warmer and all accessory items for any signs of damage which may have occurred during shipment. File a damage claim with the shipping carrier if damage has occurred. -
Page 12: Heater Assembly Rotation
2. Check that all gas accessories are installed and operating properly (refer to Section 3.9). 3. Where applicable, perform the checkout procedures detailed in the Operation and Maintenance Manuals for the accessories. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 13: Wall Mount Checkout
Decrease Tones Start/Hold Switch Apgar Mode On/Off and Reset Indicator Indicators Bed controls present on elevating bed models only. Figure 2-2 Control Panel 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 14: Control Unit Checkout Procedure
The probe failure indicator light is lit. b. There is an alternating two tone alarm. c. The overhead alarm light is flashing. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 15: Elapsed Timer Check
1. Press the Raise Bed touch switch and verify that the bed raises to a maximum of 118 cm off the floor. 6600-0371-000 6600-0371-000 10/27/03 03/07/02 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 16: Interlock Switch Check
The warmer is operating in the manual mode. b. The heat output is still set at 25% power. c. The audio power failure alarm is off. 6600-0371-000 6600-0371-000 10/27/03 03/07/02 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 17: 3/Operation
5% increments. Power settings between 0 to 25% allow operation without the 12 minute check patient alarm in the manual mode. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... -
Page 18: Indicator Lights
• Reset • Apgar Tones On/Off • Light On/OffMode Switch • Raise Bed (M) (Elevating models only) • Lower Bed (?) (Elevating models only) 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX... - Page 19 Lower Bed (? ? ? ? ? ) (Elevating Models Only) This switch lowers the bed to a minimum height of 98 cm from the floor. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
-
Page 20: Alarms
Note: Qualified service personnel can adjust the alarm to trigger at a difference of 0.5°C and reset at a difference of 0.3°C. 6600-0371-000 10/27/03 6600−0371−000−DWG MANUAL−DOC, User Reference Manual, OM Panda, English−default Reproduced from the electronic master in MATRIX...
Need help?
Do you have a question about the Panda and is the answer not in the manual?
Questions and answers