Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ECO POWER DIYSolar OFF-GRID
- Page 1 OFF-GRID DIY/CONTRACTOR KIT INSTALLATION MANUAL REV-1107.19-144000...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Warning and Disclaimer ................1 Kit Contents ......................2 Pre-Installation ....................3 Installation Pole Assembly ....................4 Battery Box Assembly ................5 Wiring ........................6 Finalization ......................7 Warranty Information ..................8... -
Page 3: Warning And Disclaimer
DO NOT RETURN THIS KIT TO POINT OF PURCHASE. You will need the bar code number on your DIYSolar Off-Grid DIY/ Contractor Kit, date and place of purchase, along with your receipt when calling sales and/or technical support. -
Page 4: Kit Contents
KIT CONTENTS The contents of your DIYSolar Off-Grid DIY/Contractor Kit are marked with removable UPC code product stickers. Where possible the sticker is kept out of sight when installed and can be left on or removed as desired. Charge controller,... -
Page 5: Pre-Installation
PRE-INSTALLATION MATERIALS REQUIRED LOCATION AND BASE SUGGESTIONS Below grade engineering is the responsibility of the purchaser. (not provided) Choose a location that has clear unobstructed views to the south (in the XX" Wrench or northern hemisphere), in order to maximize the amount of irradiance Socket set (energy) the PV panel will absorb. -
Page 6: Installation
INSTALLATION POLE ASSEMBLY 20' Model Only STEP Set into min 3200 PSI concrete as per pre-installation instructions on previous page. Once the concrete has set for 24 hours or concrete is set, ensure all six (6) bolts have been installed with rubber lock washers. -
Page 7: Battery Box Assembly
INSTALLATION BATTERY BOX ASSEMBLY STEP Using the same steps from the pole assembly instructions, attach section T1 to the top of the pole assembly. STEP Remove the front access door from the battery box (P3a), setting it and fasteners aside and secure for re-installation. -
Page 8: Wiring
INSTALLATION WIRING PV Panel not depicted for illustrative purposes only. STEP Position the PV Rack Assembly on top of P3 battery box and align 4 holes. Feed the PV cable through centre hole. Fasten securely with hardware provided; nuts and washers on the inside of P3a battery box, and bolt head and rubber washer on the outside. -
Page 9: Finalization
Remove cloth and re-install cover for P3a battery box. STEP Adjust trunnion to the irradiance degree previously calculated, or use the solar angle calculator located at www.solarelectricityhandbook.com/ solar-angle-calculator.hml CONGRATULATIONS! Your DIYSolar Off-Grid light is now fully assembled and ready for use! -
Page 10: Warranty Information
WARRANTY INFORMATION Please retain this manual and fill in the relevant details on the back cover, as they will be required for any warranty claims. Ecopower Inc. (“Seller”) warrants to the original Buyer of the Seller’s products (and not to any subsequent owner or user) that products manufactured or sold by Seller is free of defect in material and workmanship at the time of purchase and for the warranty period listed below from the original date of purchase when the product is used under normal operating... - Page 11 Solar Panel • The panels carry a thirty (30) year power output warranty unless otherwise noted on the product itself. • The panels carry a ten (10) year product warranty on materials and workmanship. Controller • The controller carries a XX (XX) year warranty No Assurances as to Results.
- Page 12 Off-Grid Contractor Kit. You will require your bar code number, and place and date of purchase. Fill out the information in the boxes above for easy future reference. DIYSolar Off-Grid Contractor Kit Bar Code Number Date of Purchase Place of Purchase For customer service or technical support, contact us at: 1.800.564.8086...
Need help?
Do you have a question about the DIYSolar OFF-GRID and is the answer not in the manual?
Questions and answers