Hannlomax HX-201Qi Instruction Manual

Wooden Table with Qi Wireless charging, USB charging, and Bluetooth
Model : HX-201Qi
Bluetooth Pairing Code : HX-201Qi HANNLOMAX
INSTRUCTION MANUAL
Note: Please read and follow these instructions before using your unit.
1. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions.
2. Do not use this apparatus near water.
3. Clean only with dry cloth.
4. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
5. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
6. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from
the apparatus.
7. Only use attachments/accessories specified by the manufacturer.
8. Unplug this apparatus during lightning storms or when unused for long periods of time.
9. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
10. Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it
from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on
a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer's instructions have been adhered to.
11. The MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
12. 回: CLASS II apparatus with double insulation, and no protective earth provided.
13. Caution Marking and rating plate was located at bottom enclosure of the apparatus.
14. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
15. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on
apparatus.
16. The mains plug is used as disconnect device. The mains plug of apparatus should not be obstructed OR should be easily accessed
during intended use. To be completely disconnect the power input, the mains plug or apparatus shall be disconnected from the mains.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
- 1 –
LOCATION OF CONTROLS
1 Mode Indicator
2 USB charging port (1A)
3 Aux-in Jack
4 Mode / Standby button
Volume −/  Button
5
Volume +/  Button
6
Note :The rating label has marked on the bottom panel of the apparatus..
Specifications
Power Supply: AC 100V-240 ~ 60/50 Hz
AC/DC adapter: DC9V ~ 3.5A
USB Rated Output: DC5V 1A
Specifications are subject to change without further notice.
7 Button
8 Bluetooth Unpair Button
9 Qi Wireless charging indicator
10 Wireless charging Pad
11 DC Jack
12 Table Leg connection
-2-