Advertisement
Section 1. Installation
IMPORTANT! This appliance must be left to stand in an upright position for
-
at least 4 hours before being switched on for the first time.
Remove all packaging and securing tape from the appliance.
-
Wash the interior of the appliance with luke warm water containing a small
-
amount of bicarbonate soda (5ml to 0.5 litres of water).
Position the appliance in a dry atmosphere and out of direct sunlight.
-
Do not position next to a cooker or other sources of heat, i.e. radiator.
-
If positioned next to another fridge or freezer, leave a minimum gap of 2cm
-
between the appliances in order to avoid condensation.
A clearance of 50mm should be left above the appliance. If this cannot be
-
achieved you should ensure a clearance of 25mm is maintained on each side
of the appliance.
Please ensure that there is a small 'air-gap' between the condenser on the
-
rear of the appliance and the rear wall.
Do not place or store heavy items on the top of this appliance.
-
Ensure that the appliance is positioned on a firm flat floor.
-
This appliance must be level. Adjust the level by screwing the adjustable feet
-
up or down (use your fingers or a suitable spanner).
Ensure that the appliance is upright and both feet are in firm contact with the
-
floor so that the cabinet is stable.
Connect the plug to an adjacent 13amp socket outlet and ensure that the
-
appliance is not standing on the supply cable.
5
Advertisement
