Advertisement
INSTALLATION INSTRUCTIONS
Getting Started
1.) Using a small screwdriver, ball point pen, etc. set the four switches on
the side of the unit (see Input Programming and Output Programming
on page 2).
2.) Mount unit into panel. (see Mounting on page 3).
3.) Connect unit to input signal, output signal, and power wiring (see Wir-
ing on page 4).
4.) Check calibration (See Calibration on page 4).
Specifications are on page 4.
Dimensions
Dimensions in mm (inches)
LOVE
®
June, 2000
Iso Verter®II
Model SC468 and SCL468
LOVE CONTROLS
a Division of Dwyer Instruments, Incorporated
PO Box 338
(800) 828-4588
Michigan City, IN 46361-0338
(219) 879-8000
www.love-controls.com
Page 1
FAX (219) 872-9057
949-0532-1
Advertisement
Table of Contents
Summary of Contents for Dwyer Instruments LOVE Iso Verter II
- Page 1 4.) Check calibration (See Calibration on page 4). Specifications are on page 4. Dimensions Dimensions in mm (inches) LOVE CONTROLS LOVE a Division of Dwyer Instruments, Incorporated PO Box 338 Michigan City, IN 46361-0338 ® (800) 828-4588 (219) 879-8000 FAX (219) 872-9057 www.love-controls.com...
- Page 2 Input Programming RANGE SELECTION SWITCH BANK (SW-1) Turn ON the switches for the scale desired. All other switches should be OFF. INPUT RANGE 1 2 3 4 5 6 7 8 RANGE 1 2 3 4 5 6 7 8 100mV 200mV 100V...
- Page 3 RANGE SELECTION SWITCH BANK (SW-4) Turn ON the switch for the scale desired. All other switches should be OFF. If BIPOLAR OUTPUT is selected, the scale will be from MINUS-SELECTION to PLUS-SELECTION (eg. -10 TO +10 VDC) RANGE 1 2 3 4 5 6 20mA = ON MODE...
- Page 4 Overcurrent: 120mAac Frequency Range: 40 to 400 Hz. Zero Adjustment: -10% to +50% of scale. Span Adjustment: -50% to +10% of scale. © Copyright 2000 Love Controls, a division of Dwyer Instruments, Inc., All rights reserved. 949-0532-1 Page 4 June, 2000...
Need help?
Do you have a question about the LOVE Iso Verter II and is the answer not in the manual?
Questions and answers