Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Fisher & Paykel AJ-RF17X
- Page 1 JOINER KIT RF135B, RF170B & RF170W models INSTALLATION GUIDE US CA...
-
Page 2: Components Required
RF135B, RF170B and RF170W with handles. Supplied We recommend you save this installation guide for future reference. ITEM PART NUMBER Kit Joiner Silver AJ-RF17X 819264 Rear bracket (1) Front lower bracket (1) Front Upper bracket (1) Centre trim (1) -
Page 3: Product Dimensions
PRODUCT DIMENSIONS – RF135B COMBINATIONS PLAN ISOMETRIC RF135B + RF135B PRODUCT DIMENSIONS A Overall height 67 3/4 1720 B Overall depth* 27 3/8 C Overall width 1295 D RF135B width *Including rear compartment cover, excluding handle. RF135B + RF170B/W PRODUCT DIMENSIONS A Overall height 67 3/4 1720... - Page 4 PRODUCT DIMENSIONS – RF170B/W COMBINATIONS PLAN ISOMETRIC RF170B/W + RF170B/W PRODUCT DIMENSIONS A Overall height 67 3/4 1720 B Overall depth* 27 3/8 C Overall width 63 1/8 1605 FRONT PROFILE RF170B/W width *Including rear compartment cover, excluding handle. Actual product dimensions may vary by up to +3/16" (5 mm).
-
Page 5: Cavity Dimensions
CAVITY DIMENSIONS – RF135B COMBINATIONS PROUD INSTALL FLUSH INSTALL Full door rotation Full door rotation 90° door rotation RF135B + RF135B RF135B + RF170B/W RF135B + RF135B RF135B + RF170B/W CAVITY DIMENSIONS CAVITY DIMENSIONS A Width of cavity A Width of cavity 52 9/16 1335 58 5/8... - Page 6 CAVITY DIMENSIONS – RF170B/W COMBINATIONS PROUD INSTALL FLUSH INSTALL Full door rotation Full door rotation 90° door rotation RF170B/W + RF170B/W RF170B/W + RF170B/W CAVITY DIMENSIONS CAVITY DIMENSIONS A With of cavity A Width of cavity 64 3/4 1645 Full door rotation 73 13/16 1875 B Height of cavity...
- Page 7 CLEARANCES PROUD INSTALL FLUSH INSTALL Full door rotation Full door rotation 90° door rotation ALL MODELS ALL COMBINATIONS MINIMUM CLEARANCES MINIMUM CLEARANCES A Side clearance A Side clearance Full door rotation 5 5/16 B Rear clearance (incl. evaporator tray) 1 3/16 90°...
-
Page 8: Installation
INSTALLATION Before you begin Check cavity dimensions are correct for the type of dual installation you require. Unpack appliances from packaging following guidance on individual cartons. Remove the rear compartment cover Ensure the floor is protected from damage during unpacking and installation. using a Phillips screwdriver. - Page 9 INSTALLATION IMPORTANT! Adjust front feet of both appliances Two people required. until level. Turn clockwise to decrease height or Carefully tilt the connected appliances anti-clockwise to increase height. backwards to access the rear feet and the lower front bracket location. Washers Remove the leveling feet from both At the top of each appliance,...
-
Page 10: Adjusting Door Alignment
INSTALLATION ADJUSTING DOOR ALIGNMENT Locate the centre trim panel assembly Ensure front leveling feet are to the tab on the lower bracket. adjusted correctly. Incorrect leveling may affect door alignment. Position the centre trim panel under the upper bracket before re-tightening the six screws. - Page 11 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2022. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue.