LampLust Sulis LC003836 Installation Instructions

INSTALLATION INSTRUCTIONS
IMPORTANT
Before opening your LampLust Sulis Stainless Steel Solar Path Lights, please
make sure that you carefully read through these instruction sheets.
NOTE: The important safeguards and instructions that appear in this manual
are not meant to cover all possible conditions and situations that may occur. It
must be understood that common sense, caution and care are factors that
can't be built into any product. This approach must be used by the person(s)
caring for and operating the path lights.
GENERAL INFORMATION
Battery installation should only be performed by an adult. Only batteries of
the same of equivalent type as recommended should be used. Battery
leakage can cause corrosion and damage to this product so please remove
non-functioning batteries immediately. Remove batteries from product
during long periods of non-use. DO NOT DISPOSE OF IN FIRE. Please
dispose at your local recycling facility.
STEP BY STEP INSTRUCTIONS
Before operating your path lights, remove packaging and assemble. Be sure to
remove battery tabs from battery compartment (located on the bottom of the
solar panel housing), in order to activate the batteries. Please note that the solar
lantern switch must be turned on in order for the battery to charge.
WHAT WE PROVIDE
• Four Stainless Steel Solar Path Lights
• 4 Metal Poles and Plastic Garden Stakes
• 8 x AA NI-MH Rechargeable Batteries (Installed)
(2 Per Path Light)
WHAT YOU NEED
• Garden Implement (to make a hole in the ground)
1
ASSEMBLY
Insert the metal poles into the bottoms of the solar path
lights. Remove the plastic stakes from the bottom of the
poles, turn around, and re-insert with pointed ends
facing out.
1
NO. LC003836