TimeTEX Silent Operating Instructions

Timer "Silent" Compact
Operating Instructions
Thank you for purchasing this product from TimeTEX.

1. Before you use the device for the first time

• Please read through the operating instructions carefully.
• Paying attention to the operating instructions will help you to avoid damaging your device, jeopardising your legal rights to
make a claim for any defects due to misuse.
• We cannot accept any responsibility for any damage that is due to a failure to comply with these operating instructions.
• Please pay particular attention to the safety instructions!
• Keep these instructions in a safe place!

2. For your safety:

• Do not use the product in any way other than that described in these operating instructions.
• Unauthorised repairs, conversions or modifications of the product must not be undertaken.
Caution! Risk of injury:
• Keep the product and its batteries out of the reach of children.
• Batteries can be life-threatening if swallowed. If a battery is swallowed, it can cause severe internal burns and death
within 2 hours. If you suspect a battery may have been swallowed or otherwise entered the body, seek medical attention
immediately.
• Never throw batteries into fire, short-circuit, disassemble, or recharge them. Danger of explosion!
• Batteries contain acids that are harmful to health. To avoid battery leakage, replace weak batteries as soon as possible.
• Wear chemical-resistant protective gloves and goggles when handling leaking batteries!
Important notes on product safety!
• Do not expose the product to extreme temperatures, vibrations or impact.
• Protect from moisture.

3. Setup:

• Open the battery compartment.
• Insert two new 1.5 V AA batteries with the correct polarity.
• A short alarm sound is emitted.
• Close the battery compartment again.
• Slide the volume control above the battery compartment to the desired position (see 4.1).
• The device is now ready to operate.

4. Operation:

• Place the timer on a smooth, level surface, folding out the stand first.
• The integrated rear magnets also allow the timer to be attached to a magnetic surface.
• The timer can also be hung on the wall using the keyhole recess on the back.
• Set the desired time (1 - 60 minutes) using the knob. The time left is marked with a coloured time remaining indicator.
• The countdown begins, and the coloured time remaining indicator gets gradually smaller.
• Once the time has elapsed, an alarm sounds at the set volume.
• The alarm sound can also be switched off completely (see 4.1).
• To stop the alarm, turn the knob slightly to the right then back to its default position.