BELTTT BECL10A Operation Manual

BECL10A
Battery Charger
Operation Manual
To provide you reliable service, the battery charger should be installed and operated properly.
Please read this operation manual before you do anything, read all the indications, especially the
warnings or conditions which might damage the device or hurt yourself, great attention is demanded.
Please read the "Safety Caution" first to make sure proper operation, and safe keep it with
warranty card for future reference.

Introduction

CHG series lead-acid battery charge is professionally designed for electric vehicle's batteries.
It uses PLUS Width Modulation (PWM) technology and features by small size, easy installation,
efficient transfer, longtime operation, stable current, high capacity, good reliability and long
lifespan. Functions include short circuit protection, reverse connection protection, etc.

3-step charging mode

Constant current: When the battery voltage is lower than charger's setting voltage, the charger
will charge the battery with constant current.
Constant voltage: The PWM technology can strictly control the charging current and output voltage,
to ensure the battery is fully charged but avoid over charged.
Floating charge: When the battery voltage is close to charger's setting voltage on constant voltage
mode, and charging current drops to setting current, that is, the battery is fully
charged, the indicator will changes to green. The charger will automatically
transfer to floating mode. Remove the charger or float charging are both
available.
BECL20A BECL25A BECL50A